Water Heaters (HVAC)

Water Heater has double-wall heat exchanger.
Water Heaters (HVAC)

Water Heater has double-wall heat exchanger.

Constantemp heater provides instantaneous hot water at desired temperature. Heat exchanger consists of tube within tube, with air space in between to prevent contamination of potable water by toxic heating substance. Feed-forward blending device ensures hot- and cold-water blend ratio is accurately proportioned to maintain set temperature for flow demands up to 7,200 gph. Integrated fail-safe...

Read More »
Water Heaters (HVAC)

Water Heaters feature dual O-ring system.

BoilerMate(TM) Series tanks have seamless inner corrosion-proof, nonmetallic, polyethylene reservoirs, and CFC-free molded insulation. Dual O-Ring Sealing System for WH-7 and WH-9 Series water heaters provides second seal that protects interior section of water heaters. Dual O-ring offers confirmation of seal and guards against future leaks. If seal is not secure, second O-ring inhibits internal...

Read More »
Water Heater Module mounts to wall.
Water Heaters (HVAC)

Water Heater Module mounts to wall.

DHW Green Hot Water Heater Module, for domestic hot water heating, eliminates cold showers when connected to hydronic boilers. Capacity range is 75,000-400,000 Btu/hr, with up to 1,000,000 Btu/hr available when full boiler hot water heating and fast recovery are required. System module includes heat exchanger, pumps, hand and balancing valves, temperature gauges, control interface and electrical...

Read More »
Water Heaters (HVAC)

Water Heaters have dual O-ring sealing system.

Indirect-fired Series WH-7 and WH-9 BoilerMate(TM) Classic incorporate sealing system which provides second seal that acts as backup for protection of interior section of water heaters. Sealing system disperses water that leaks down exterior sides of water heater if seal is not secure and inhibits internal water heater damage caused by internal leaks. Products use seamless inner corrosion-proof,...

Read More »
Water Heaters (HVAC)

Gas Water Heater/Boiler provides installation flexibility.

Commercial Copper-Fin II provides 990,000-2,070,000 Btu/hr and 85% (water heater) and 84% (boiler) efficiency. Unit incorporates independent dual-ignition systems, gasketless heat exchanger, and multiple referenced gas valves. Multiple blowers maintain proper airflow, while built-in sequencer automatically controls each function. With 7 venting options, multi-stack frame unit has fan-assisted...

Read More »
Water Heaters (HVAC)

Gas Water Heater can be used in negative air conditions.

With fully condensing, sealed combustion chamber, tank type TurboCharger(TM) is suited for tight mechanical rooms. Unit offers direct vent design, which draws all combustion air from outside and vents all byproducts outdoors. Submerged combustion chamber, premix power burner, and triple pass flue system create thermal efficiencies to 98%. Single model configuration is offered with storage...

Read More »
Hot Water Tanks add storage to existing water heaters.
Water Heaters (HVAC)

Hot Water Tanks add storage to existing water heaters.

StorageMate(TM) insulated tanks are offered in 41, 80, and 119 gallon models. Smallest model utilizes dense, polyethylene liner, while larger models are constructed of stainless steel. Tanks can function as recirculating aquaboosters with tank-less coils, hydronic buffer tanks for low-mass boilers and radiant systems, and as additional storage. Optional mechanical aquastats control temperature....

Read More »
Water Heater and Booster are made of stainless steel.
Water Heaters (HVAC)

Water Heater and Booster are made of stainless steel.

Indirect Water Heater and Booster maintain hot water temperature with heat loss of under 1/2° per hour. This is made possible via 2 in. CFR Flame Retardant soft foam insulation. Reinforced stainless steel tank base eliminates pressure stress on tank bottom. Aquastat control (thermostat) sits within well space, which enables replacement if tank needs to be drained. Construction includes...

Read More »
Krueger Sentry Gauge Announces the Release of Two New Chemical Sight Gauge Models Designed for Aggressive Liquid Storage Monitoring
Sponsored

Krueger Sentry Gauge Announces the Release of Two New Chemical Sight Gauge Models Designed for Aggressive Liquid Storage Monitoring

Krueger Sentry Gauge, a leader in chemical sight gauges, now offers the ultimate in aggressive liquid storage monitoring devices. From sulfuric and hydrochloric acid to bleach, and acetone, our products are designed with robust features that deliver a long and trouble-free service life. See our video to learn all about this new and innovative line of sight gauges.

Read More »

All Topics