Universal Process / Temperature Controllers

AutomationDirect Introduces SOLO Basic Temperature Controllers to Provide Single Loop Control for Heating and Cooling Processes
Universal Process / Temperature Controllers

AutomationDirect Introduces SOLO Basic Temperature Controllers to Provide Single Loop Control for Heating and Cooling Processes

UL, CUL and CE approved controllers have two 4-character 7-segment LED display to indicate process value (PV) and setpoint value (SV); red for PV and green for SV. IP66 rated for dust and water jet ingress protection (inside suitable enclosure) and have a 0°C to 50°C operating temperature range. Accept 11 types of thermocouples, 4 types of RTD temperature sensors and support three control...

Read More »
Partial Precision Landing in Short Cycles
Universal Process / Temperature Controllers

Partial Precision Landing in Short Cycles

Flexible tool temperature control solution Z-System from hotset impresses injection molders The thermodynamics engineers at hotset have hit the jackpot with the development of the Z-System for partial-cyclical cavity temperature control. More and more injection molders and tool manufacturers are choosing to use this high-speed method thereby optimizing the surface and structural design of their...

Read More »
Fujitsu New Cooling Control Technology Determines the Rate of Introduced Outside Air
Universal Process / Temperature Controllers

Fujitsu New Cooling Control Technology Determines the Rate of Introduced Outside Air

The Cooling Control Technology is designed to reduce the energy consumption in datacenter cooling equipment. This technology uses control algorithms to analyze past changes in temperature distribution in the room when temperature settings of the equipment are performed. It controls the outside-air introduction that is based on cooling device energy efficiency. The technology controls the ratio of...

Read More »

All Topics