Turbines

Gas Turbine suits industrial applications in 6 MW range.

Gas Turbine suits industrial applications in 6 MW range.

Cold-end-drive, single-shaft Taurus(TM) 65 generator suits cogeneration, combined cycle, and other power generation applications. Generator set is rated at 6000 kWe for continuous duty at ISO conditions. It features 13-stage axial compressor with 15:1 pressure ratio that produces air inlet flow of 19.4 kg/sec, and utilizes 3-stage turbine with shrouded stage-3 turbine blade. SoLoNO(TM) combustion...

Read More »

Miniturbine suits industrial power generation applications.

Based on aero-derivative natural gas fired turbine, ENT 400 is designed for applications where its exhaust gas can be used for direct heating and drying applications. Product provides up to 6 MMBtu/hr of heat as direct exhaust at 27,450 lb/hr at 1013Â-ºF and 396 kW of continuous electric power. System is fully integrated in compact container and includes all controls and utility switchgear.

Read More »

Precision Turbine incorporates governed design.

DotcoÂ-® 12R91 series precision turbine allows tool to idle and provides full power under load. Pre-loaded bearings maintain stability in spindle to allow for smoother cuts. Available with 3 mm and 1/8 in. collets, 65,000 rpm rear exhaust governed tool suits applications that previously used 100,000 rpm non-governed tools. It is available in models with 2 and 4 ft overhose to direct exhaust...

Read More »

Gas Turbine offers improved efficiency.

Built upon Frame 6FA gas turbine technology, Model PG6111FA offers output increase to 75.9 megawatts and heat rate improvement of 2.7% over previous model. Combined-cycle service provides 117.7 megawatt output with 54.7% efficiency. Firing temperature is rated to 2420Â-

Read More »

All Topics