Electronic Boards

Electronic Boards

A/D VME Board handles high frequency applications.

Model 6802 has 32 channels of delta sigma A/D conversion with extremely precise, linear-phase low pass filtering. Each A/D has 24 bits of resolution at sampling rates from 1 kHz to 216 kHz. Front-panel sync input signal allows synchronization of multiple 6802 boards. Outputs of up to eight 6802 boards, for maximum of 256 channels, can be combined over single FPDP cable. Data tagging is also...

Read More »
Electronic Boards

I/O Cards provide zone control.

1799-ZCIOV (sinking output) and 1799-ZCIOB (sourcing output) modules include Zone Interlocking Protocol, a parameter-based technology that allows 1 card to consume data directly from up to 4 other ZCIO cards, providing response time of 2 msec. ZCIO cards are designed for applications where machine provides enclosure for I/O or where I/O board fits into field replaceable unit. DeviceNet(TM) is...

Read More »
I/O Card supports data rates up to 50 MHz.
Electronic Boards

I/O Card supports data rates up to 50 MHz.

GC5050 high-speed dynamic digital I/O card has built-in Algorithmic Sequencer that plugs into any PCI slot and allows users to create loops and branches to manipulate output vectors. It provides real-time digital stimulus and capture with 32 pins per card. Up to 16 cards may be daisy-chained for total of 512 pins. Memory behind each pin is configurable from 256 Kbit to 1 Mbit and is user...

Read More »
Interface Boards connect to Galil motion controls.
Electronic Boards

Interface Boards connect to Galil motion controls.

VARIOFACE interconnect for Galil OPTIMA and ECONO series digital motion controllers can be used directly with Galil's 100, 80, and 36-pin cables. The 100-pin version comes with additional amplifier driver circuit and discrete screw connection to all conductors of Galil cable. Specific marking of each connection allows for quick, space-saving installation. Module is available as DIN-Rail or...

Read More »
How to Choose the Right Adhesive Tape for Your Application
Sponsored

How to Choose the Right Adhesive Tape for Your Application

With a considerable number of adhesive materials, applications and methods, there are many options to consider when choosing an adhesive tape. As NADCO® is a leading manufacturer of custom tapes and labels; we took our years of experience to create this handy selection guide on choosing the right adhesive tape for your application.

Read More »
Serial I/O Adapter fits CompactPCI-based computers.
Electronic Boards

Serial I/O Adapter fits CompactPCI-based computers.

ISO COMM2.cPCI multi-interface I/O adapter provides two individually selectable RS-232/422/485 isolated serial ports that support data rates up to 921.6 Kbps. True port to port optical isolation eliminates effects of ground loop current. It isolates not only signals, but also isolates ports from each other. Auto-enable hardware automatically handles RS-485 driver, allowing RS-485 ports to be...

Read More »
Electronic Boards

Carrier Board provides mass storage.

IPM-ATA multi-purpose 3U extension board plugs into single slot and houses IDE 2.5 in. hard dirves, microdrives, or solid-state IDE FLASH or Compact FLASH drives. Up to 2 devices, configured as master and slave, may be plugged in. Standard IDE ribbon cable connects IPM-ATA to rear I/O transition module of master rear I/O CompactPCI backplane connector, where embedded SBC's secondary channel of...

Read More »
Electronic Boards

Boards turn PC into measurement system.

PCI-DAS6025 and PCI-DAS6023 plug into PCI slot. Both offer 16 channels of 12-bit A/D measurements that may be taken at rates to 200,000 samples/second. Eight discrete digital bi-directional I/O lines control relays and solenoids, and monitor switch and contact closures. Each board supports 2 counters. PCI-DAS6025 has two 12-bit analog outputs and additional 24 digital I/O lines. Applications...

Read More »
Embedded Board has biscuit (EBX) form factor.
Electronic Boards

Embedded Board has biscuit (EBX) form factor.

EBC-7850 3.5 in. disk-size embedded board supports Socket 370-based Pentium(R) III processor or Celeron(TM) 400 processor. Intel(R) 815E chipset provides up to 133/100 MHz front side bus speeds and 133 MHz for system memory. A 144-pin SO-DIMM socket allows up to 256 MB of SDRAM support. EBC-7850 has on-chip VGA controller with up to 1600 x 1200 resolution at 256 colors, 10/100 Mbps Ethernet, and...

Read More »
Electronic Boards

Computer Boards suit embedded applications.

Six PC/104 boards include: 90 W Power Distribution Vx for dc to dc power conversion; ipLINK Web Appliance Core I/O server for remote monitoring, maintaining and controlling Internet-enabled devices; GPS Interface carrier board for Global Positioning System receiver; PCMCIA 2-slot connector and controller board; CDMA Carrier module for wide-spectrum communications applications with fixed, mobile...

Read More »
Serial Boards are PCI 2.2 compliant.
Electronic Boards

Serial Boards are PCI 2.2 compliant.

Multi-port, serial Low Profile PCI Boards are built on 32-bit addressing, and can be used in either standard or low-profile PCI backplanes. They adhere to MD1 board length specification, and fit all 2U rack mount systems without using riser cards. Boards offer 4-layer design, shared interrupts, 16-byte FIFOs, and board speeds up to 921.6 kbps. Universal PCI connector is compatible with 3.3V and...

Read More »
Sentry Equipment Introduces New Compact Hygienic Automatic Sampler
Sponsored

Sentry Equipment Introduces New Compact Hygienic Automatic Sampler

As a leader in industrial sampling equipment at Sentry Equipment, our success is built on a history of innovation and designs that epitomize value and efficiency. The new Hygienic Automatic Sampler is another example of our dedication to developing quality engineered products. To learn how this product can streamline the sampling process for dry, free-flowing materials, see our new video.

Read More »

All Topics