Analog Devices, Inc.

Architectural & Civil Engineering Products

FMC Prototyping Kit aids JESD204B ADC-to-FPGA connectivity.

Used to prototype high-speed JESD204B ADC-to-FPGA platforms, AD9250-FMC-250EBZ FPGA mezzanine card (FMC) featuresÂ- 2 AD9250 dual 14-bit JESD204B data converters. Kit provides four 14-bit ADC channels at 250 MSPS in FMC-compliant form factor. ADCs support Subclass 0 and 1 deterministic latency and provide SYNCREF signal for synchronization of all 4 channels, providing...

Read More »
Communication Systems & Equipment

Isolated Error Amplifiers operate at less than 7 mA.

Designed for linear feedback power supplies using primary side controllers, ADuM3190 and ADuM4190 have 400 KHz bandwidth, with 0.5% typ initial accuracy at 25°C and 1% total accuracy over temperature range of -40 to +125°C. With included iCoupler®Â-  technology, amplifier eliminates current-transfer ratio of optocouplers that degrades over lifetime of devices. Combining...

Read More »
Electrical Equipment & Systems

New Version of Analog Devices' Simulation Tool Significantly Eases Development of RF Systems

NORWOOD, Mass.-- Analog Devices, Inc. (ADI) today announced the release of a new version of its popular ADIsimRF™ design tool. The free design tool is the software accompaniment to ADI's complete portfolio of RF-to-digital functional blocks, allowing engineers to model RF signal chains using devices from across ADI's RF IC and data converter portfolio. ADIsimRF Version 1.7 adds a number of new...

Read More »
Electrical Equipment & Systems

D/A Converter provides ±2-LSB INL relative accuracy.

Operating from single 2.7–5.5 V supply, nanoDAC® AD5689R includes SPI interface, 2.5 V, 2 ppm/°C internal reference, and useful pin functions such as VLOGIC facilitating 1.8, 3, and 5 V logic levels. Dual, 16-bit converter features total unadjusted error of 2 mV, eliminating need for initial calibration and adjustment. Housed in 3 x 3 mm, 16-lead LFCSP or 16-lead TSSOP, device...

Read More »
Agricultural & Farming Products

Clock Buffer and Divider IC delivers extremely low jitter.

Housed in 24-lead LFCSP package, 1.65 GHz Model AD9508 delivers low jitter of 41 fs across 12 kHz to 20 MHz band. Device has 4 dedicated output dividers with bus-programmable division and phase delay, and automatic synchronization. Dividers also have pin-strapping capability for hardwired programming at system power-up. Operating from -40 to 85°C, Model AD9508 supports up to 4 differential,...

Read More »
Communication Systems & Equipment

Operational Amplifier suits front-end amplifier circuits.

Specified for dual voltage supply operation from ±5 V to ±15 V, Model ADA4077-2 has typical bandwidth of 3.9 MHz and 7 nV/√Hz voltage noise at 1 kHz while consuming only 400 Â-µA typical at 25°C. Unit is available in 2 grades for offset and thermal drift. Op amp is specifically designed for applications in process control, chemical and environmental monitoring,...

Read More »
Communication Systems & Equipment

Two-Channel Differential Amplifier drives high-frequency ADCs.

Suited for driving 12- to 18-bit ADCs, ADL5566 features 3 dB bandwidth of 4.5 GHz and comes in 4 x 4 mm, 24-lead LFCSP. Product is optimized for wideband, high IF (intermediate frequency), low distortion, and noise performance out to 500 MHz. Â- At 100 MHz, device achieves respective IP3 and IP2 values of 51 and 100 dBm. Design supports detailed specifications at 70, 100, 140, 250, 500, and...

Read More »
Electrical Equipment & Systems

DAQ IC simplifies industrial, instrumentation equipment design.

Optimized to interface with sensors running from ±10 V to ±640 mV, ADAS3022 integratesÂ- complete precision data acquisition (DAQ) analog signal chain in one 6 x 6 mm, 40-lead LFCSP. This 1 MSPS DAQ IC, rated from -40°C to +85°C, specifically integrates 16-bit PulSAR® successive-approximation ADC core with high-impedance input buffers and 7-stage on-chip...

Read More »
Laboratory and Research Supplies and Equipment

Analog Devices to Host 'Name That Beer' Demonstration Using Spectrometer Technology from Wasatch Photonics at Electronica 2012

At ADI's booth (Hall A4, Stand 159) Wasatch will identify the signature spectrum of 10 brands of beer using a Raman spectrometer incorporating ADI's A/D converter technology electronica 2012 MUNICH - Analog Devices, Inc. (ADI) is teaming up with Wasatch Photonics, Inc. at electronica 2012 (November 13-16) to stage a Name That Beer" demonstration using the Wasatch Photonics Stroker 785L Raman...

Read More »

All Topics