Dwyer Instruments, Inc.
Michigan City, IN 46360
Dust Collector Diaphragm Valves have springless design.
Suited for use with Series DCT1000 and Series DCT500 duct collection timer boards, Series DCS/RDCS offer option for coupling or NPT connections. Coupling connection facilitates installation, requiring only stub pipe and blowtube to be cleaned and deburred before valve is fit into position. T-Series DCS has female threaded connections, while C-Series DCS has coupling connection. Both have 90Ã-
Read More »Temperature Sensors target building management systems.
With temperature limits of -40 to 302Ã-
Read More »Needle Valve features all PTFE and PCTFE wetted parts.
Designed for laboratory and industrial applications, Model TNV is used to regulate corrosive gases and liquids for high-purity services. Media only comes in contact with PTFE and PCTFE, and valve spindles are made of rigid PCTFE to minimize creeping. Suited for use in pressure or non-critical vacuum applications, product can also be used as shut off valve. Temperature and pressure limits are...
Read More »Cable Pull Switch isolates power in case of shut-downs.
Supplied in die cast aluminum housing rated to IP67, Series CPS can isolate power to conveyor system or other similar process equipment in case of shut-down condition. Steel wire is placed along side of conveyor and attached to cable pull switch. When cable is pulled at any point along conveyor, it will trip cable pull switch and cause conveyor to shut down. Manual reset of CPS is required to...
Read More »Belt Alignment Switches offer adjustable actuation angles.
Housed in die cast aluminum with NEMA 6 rating, Series CBAS Switches are each equipped with 2 micro switches, allowing one actuation angle for small conveyor belt deviations and second actuation for extreme belt deviations. Actuation angles are factory set at 20Ã-
Read More »Temperature/Humidity Logger offers flexible programming.
Able to record temperatures from -40 to 185Ã-
Read More »Dial Pressure Gages suit limited space applications.
Designed for monitoring high-pressure gases and liquids, Series SGC2 is housed in rugged case with 1/8 in. male NPT center back connection. One inch gages are constructed with bronze spiral tube, chrome plated brass housing, and plastic lens. Featuring pressure limits of 1.1 x FS and accuracy of Ã-
Read More »Electromechanical Relay has quick-connect terminals.
Series EMR electromechanical relay includes quick-connect terminals for simple connection as well as Class F insulation for maximum coil temperature of 155Ã-
Read More »Power Supply targets building automation applications.
Equipped with 3 A fuse that protects power supply from over-current conditions, Series BPS converts 24 Vac to regulated DC power source for transmitters with 4-20 mA outputs. Output voltage can be field adjusted from 1.5-27 V using potentiometer. Snap-on bracket can be surface mounted to any flat surface.
Read More »Gas Pressure Test Kit detects leaks in gas lines.
Series LPTK Gas Pressure Test Kit is suited for testing LP and natural gas lines and controls. It includes gauge with 3% FS accuracy that indicates whether proper pressure is present or if leak exists. Calibration screw is located on back of gauge. Available in 2 different gauge ranges, product also comes with case for durability and safe handling.
Read More »