Wastewater Treatment Systems

Waste Handling Equipment, Chemical Processing & Waste Management, Green & Clean

Membrane Process addresses ZLD and high recovery plant needs.

September 4, 2015

Intended for facilities requiring Zero Liquid Discharge (ZLD) or very high recovery, AquaR2RO™ features membranes configured to handle difficult-to-treat waters. Design tolerates feed characteristics high in organics, dissolved oil, and turbidity. In addition to maximizing recovery, process minimizes volume of concentrate to treated in thermal-based ZLD with brine concentrator and/or crystallizer. In some applications, this membrane process achieves >98% recovery. Read More

Waste Handling Equipment, Green & Clean

Wastewater Treatment System targets oil and gas industry.

June 9, 2015

Used in oil recovery projects, Once-Through Flash™ technology recycles thermal heat produced by Once-through Steam Generators. Recycled heat is then used to convert produced water into clean water with high purity. OTF yields water recycle rates of more than 95%, thus achieving compliance with Alberta Energy Regulator’s Directive 081 that sets water disposal limits and includes detailed reporting requirements for thermal in situ oil sands operations. Read More

Chemical Processing & Waste Management, Waste Handling Equipment, Green & Clean

Wastewater Filtration System helps save water in car washes.

June 3, 2015

To save water during car wash operations, Hydrokleen Wastewater Filtration System takes 100% of all collected wash water, filters it, eliminates odors, and recirculates water back into existing washing system. Whether system is manual wash wand or automated wash bay, only fresh water required is for final rinse to remove recycled water used for washing from vehicle. System is completely above ground so no additional construction is necessary. Read More

Waste Handling Equipment

Non-Fouling Aeration System provides high impact mixing.

February 9, 2015

Employing non-fouling Dif-Jet™ gas injectors to mix large quantities of dissolved oxygen into wastewater, Aeration System eliminates odor and reduces BOD in animal waste and sanitary waste lagoons. System uses 400–1200 gpm shore based dry pit type, glycol cooled, electric submersible pumps designed to handle solids up to 3 in. diameter. Oxygenated wastewater is returned to wastewater lagoon at 550 gpm via discharge pipe, establishing vigorous circulation in lagoon. Read More

Laboratory and Research Supplies & Equipment, Waste Handling Equipment

Ultrafiltration Membrane Bioreactor reduces energy usage.

November 26, 2014

Suited for wastewater treatment, PURON® MBR series features braided membrane fibers that minimize downtime/breakage. Module has single-header design, and reinforced PVDF hollow fibers are fixed only at bottom to minimize buildup of hair and fibrous materials. Solids and particulates, including bacteria, remain on outside, while permeate is drawn through membrane to inside of fibers. In center of fiber bundle, aeration nozzle scours entire length of fibers and minimizes power consumption. Read More

Test & Measuring Instruments, Waste Handling Equipment, Services

Water Treatability Testing offers facility-specific options.

November 3, 2014

Treatability lab performs water reuse feasibility studies, develops treatment programs, conducts full treatability analysis, and trains operators on water treatment chemistry. After test request, treatability analysis report provides water study results and conclusions. This includes recommendations for most effective treatment program for that facility's wastewater. Water reuse feasibility rating can also be provided, which details how much wastewater can be recycled back into facility. Read More

Laboratory and Research Supplies & Equipment, Waste Handling Equipment

Biological Wastewater Treatment System is built for efficiency.

August 29, 2014

UOP XCeed™ removes organic and inorganic contaminants from industrial wastewater streams to enable discharge or reuse. Based on immobilized cell bioreactor technology, integrated bioreactor system employs mechanical design that minimizes energy consumption and required operator attention. Treatment process can be delivered as modular system and incorporates mixed-media support for immobilized bio-catalysts or microbes. Biological ecosystem results in efficient BOD removal with minimal sludge. Read More

Mechanical Components & Assemblies, Waste Handling Equipment

Portable Dialysis Water Treatment System uses heat disinfection.

May 2, 2014

Cleared by FDA, Centurion has flow rate of 1,500 ml/min based on 50°F supply. Integrated heat disinfection design disinfects entire unit — including membrane and delivery lines up to inlet of dialysis machine — in one step. Intended for use in medical facilities or at home, this single patient unit has built-in UF device that enhances microbiological quality to UPW levels ie <0.03 endotoxin units and <0.1 cfu/ml bacteria — making water suitable for hemodialysis as well as hemodiafiltration. Read More

Chemical Processing & Waste Management, Fluid & Gas Flow Equipment, Machinery & Machining Tools, Waste Handling Equipment

Submerged Ultrafiltration Membranes target MBR facilities.

March 14, 2014

Intended for wastewater treatment and recycle applications, EnviQ™ Series optimizes operation and maintenance of Membrane Bioreactor facilities. Design offers ultrafiltration quality product water with rugged PVDF flat sheet membrane. Reverse diffusion and specially designed air diffusers maximize scrubbing efficiency. Available in E-8C, 16C, and 32C configurations, membranes offer surface area of 80, 160, and 320 m², respectively. Read More

Chemical Processing & Waste Management, Waste Handling Equipment

Ultrafiltration System suits municipal water treatment.

February 6, 2014

Featuring modular design, MEMCOR® CP II Ultrafiltration Membrane System can accommodate up to 28 L40N-type membrane modules on single MemRACK™ unit, which integrates feed, air, filtrate, and waste headers into one assembly. Fully assembled, self-supporting racks are then manifolded together to form functional arrays. Minimizing backwash duration for maximum uptime, system has piping connections to facilitate installation, and side and top module access points for in-place service. Read More

Chemical Processing & Waste Management, Waste Handling Equipment

MVR-Based Evaporator reduces wastewater disposal expense.

January 16, 2014

Suited for use where waste stream is 70–99% water, Generation 3 MVC Evaporator converts industrial wastewater into clean distilled water by removing oils, soaps, solids, and other contaminants. Resulting water can be reused in processes or safely dumped into sewer. As standalone solution or part of multi-step wastewater treatment system, solution uses Mechanical Vapor Recompression Technology; can simultaneously process multiple waste streams; and comes in 40–4,000 gph standard capacities. Read More

Plant Furnishings & Accessories, Waste Handling Equipment

Control/Monitoring System enhances wastewater utilities.

October 17, 2013

Providing connected control and monitoring for rural wastewater facilities, Pump Station Appliance is pre-engineered and pre-programmed and comes fully-assembled for facilitated installation. Purpose-built solution, configured online, is built on PACSystems RXi platform. Communications are provided over secure 3G VPN connection, enabling 24/7 access to operations data from anywhere. Also, upgradeable system will send operators email alarm notifications if problems occur at remote site. Read More

Green & Clean, Waste Handling Equipment

Wastewater Treatment System targets lift stations and wet wells.

October 11, 2013

Utilizing Green technology, Little John Digester provides oxidation and removal of FOG (Fats, Oils, and Grease), matting, odor, and corrosion in lift stations, grease traps, and wet wells. FOG is converted on contact into suspended micro-fine particulates, which are kept in constant suspension to prevent them from reforming in discharge lines. With no moving parts, system operates with low pressure, high volume airflow provided by regenerative blower located outside pumping station. Read More

Waste Handling Equipment

Wastewater Treatment System eliminates re-circulation loops.

August 23, 2013

Used for removal of total suspended solids, oils, fats, and grease, Gas Energy Mixing (GEM) system lets operator start or stop system at any point of time and run it for any duration without sedimentation concerns. In entire process, wastewater is treated in Liquid Solid Gas Mixing (LSGM) heads and thereafter reaches floatation tank. As complete process happens within LSGM heads, operator can introduce changes in chemical composition and see effective results within seconds. Read More

Waste Handling Equipment

Phosphorus Removal Unit counters blue-green algae proliferation.

April 29, 2013

Used to remove phosphorus coming from residential wastewater discharges, Self-Cleaning DpEC unit is based on electrocoagulation principle and certified to requirements of standards CAN/BNQ 3680-600 and NQ 3680-910. Industrialized solution activates only when wastewater enters system, minimizing energy consumption. Functionality provides property owners living in sensitive areas with additional support regarding standardization of inadequate septic installations. Read More

Laboratory and Research Supplies & Equipment, Waste Handling Equipment, Services

Gas Infusion Device aerates wastewater.

March 5, 2013

Instead of making bubbles, Dif-Jet™ infuses oxygen from air or pure oxygen into water. Typical infusion rates are 90–95% dissolved oxygen using air and well above saturation levels using pure oxygen. Design allows treatment without fouling, as well as mixing of multiple gases into water when desired or required. Available in PVC and stainless steel construction, Dif-Jet can be used to reduce chemical oxygen demand and biological demand levels in wastewater. Read More

Laboratory and Research Supplies & Equipment, Waste Handling Equipment

Bioreactor System targets wastewater treatment applications.

December 20, 2012

Aqua-EMBR Enhanced Membrane Bioreactor consists of activated sludge extended aeration biological treatment process and Ultrafiltration membrane system for separation of activated sludge from treated effluent. UF membrane is positioned outside bioreactor tank, rather than submerged in bioreactor tank or downstream membrane tank. Featuring tight membrane pore size of 30 nm nominal, system is suited for wastewater treatment or reclamation in new industrial and municipal wastewater treatment plants. Read More

Chemical Processing & Waste Management, Waste Handling Equipment

Portable Fluid Reclamation Unit does not hault production.

November 29, 2012

Requiring minimal operator interface, SumpDoc™ can be wheeled next to machine tool, parts washer, or rinse tank to provide fluid reclamation in 3-step process. Complete coolant restoration and rejuvenation treatment of metalworking fluids in machine tool sump does not interrupt production cycle. Components include sump cleaner, pleated bag filter and housing, continuous flow tramp oil coalescer, centrifuge, ozone generator, coolant makeup system, and electrical controls with touchscreen. Read More

Chemical Processing & Waste Management, Waste Handling Equipment

Dewatering-Clarifying Screener separates solids from liquids.

September 21, 2012

Featuring anti-blinding spray-wash system, Vibroscreen® Dewatering-Clarifying Screener separates solid materials from liquids on batch or continuous basis. Imbalanced weight gyratory motor affixed to housing imparts vibration, causing solid particles to move across screen and exit through upper discharge spout, as liquid flows through screen apertures. Available in 18–100 in. diameters, system features 4–12 spray-wash nozzles, depending on screen diameter. Read More

Chemical Processing & Waste Management, Waste Handling Equipment

Engineered Filtration System features fully automated design.

May 1, 2012

Combining ceramic flat sheet membranes, pre-assembled filtration components, and fully automated controls, Engineered Filtration System provides quick connections from membrane towers to filtration components. System includes option for remote monitoring and is suitable for variety of applications, including membrane bio-reactors, tertiary treatment, industrial process wastewater treatment, pre-filtration to reverse osmosis, ground water treatment, and landfill leachate. Read More