Spin Trimmer handles offset and wide-mouth bottles.
December 13, 2004 - Model MTM 742 can trim up to 150 offset neck containers per minute and is suitable for bottles made of any resin. System can change over from one bottle to another with no tooling change. It is targeted toward stretch blow and extrusion blow molding companies.
(Archive News Story - Products mentioned in this Archive News Story may or may not be available from the manufacturer.)
Original Press release
Lectro Engineering Co.
1643 Lotsie
St. Louis, MO, 63132
USA
Lectro Introduces Versatile Low Cost Off Set Neck Trimmer
Lectro Engineering’s MTM division has designed a system capable of trimming a wide range of off set neck and wide-mouth bottles on the same unit. This revolutionary spin trimmer will reduce equipment and maintenance cost associated with current off set neck applications.
The MTM 742 can trim up to 150 off set neck containers per minute and is suitable for bottles made of any resin. The cost of the unit is a fraction of comparable machines and is unmatched in its ability to change over from one bottle to another quickly and effectively with no tooling change.
The technology is patent pending and seen as a breakthrough for a wide range of stretch blow and extrusion blow molding companies looking to increase market share with new bottle designs.
For more information you can contact us at: Lectro Engineering 1643 Lotsie St. Louis, MO 63132. By phone at 314-567-3100 or fax at 314-567-3466 or visit our website at www.lectrotreat.com.
|
|
|
|
|
|
|
|
|
|
| 
