Lathe Chuck Shields provide OSHA and ANSI safety compliance.
December 6, 2006 -
Able to deflect chips and coolant, 3/16 in. thick polycarbonate heavy-duty lathe chuck shields provide barrier between chuck, workpiece, and operator. Shields hinge up to left and out of way for changing chuck, using chuck key, and changing the workpiece. Operator doesn't need to reach over chuck to change workpiece, and shields will not interfere with lathes that have rear guard/backsplash.
(Archive News Story - Products mentioned in this Archive News Story may or may not be available from the manufacturer.)
Original Press release
Danray Products LLC
11859 Deacon Drive
Rockton, IL, 61072-9411
USA
New Lathe Chuck Shields
Safeguard Personnel for OSHA and ANSI Safety Compliance
Rockton, Illinois, November 29, 2006: Danray Products LLC has just released a line of heavy-duty lathe chuck shields that are designed to apply to lathes or other similar machine applications. The 3/16"-thick polycarbonate shields provide a barrier between the chuck and workpiece and the operator. The shields also deflect chips, coolant, and other particles. The shields hinge up to the left and out of the way for changing the chuck, using the chuck key, and changing the workpiece. The operator doesn't need to reach over the chuck to move the shields in and out of position (which is a possible safety hazard), and the shields will not interfere with lathes that have a rear guard/backsplash. These shields comply with OSHA 29 CFR 1910.212 and ANSI B11.6 safety standards for machine tools.
Our lathe chuck shields are proudly made in the United States of America!
|
User comments about this story
lathe chuck shields
we are looking for lathe chuck shields do you have any supplier in the saudi arabia thanks.
By ayesh on Jun 8, 2010 02:50
Reply to this comment
Replies to this comment:Danray Products LLC
Dear Ayesh,
No, we do not have any suppliers in Saudi Arabia, but you may purchase our lathe chuck shields directly from us.
Thanks,
Danray Products LLC
By Ryan Ebens on Jun 8, 2010 09:56
|
|
|
|
|
|
| 
