Latest New Product News from
Analog Devices, Inc.
With AD-FMCDAQ2-EBZ Kit, digital and analog designers can prototype JEDEC JESD204B SerDes GSPS data converter-to-FPGA interface on major FPGA platforms, including Xilinx’s UltraScale FPGA and Zynq All Programmable SoC devices for radar, instrumentation, wireless radio, and other DAQ applications. FMC form factor enables users to verify hardware and processing algorithms and rapidly move from prototype to production, minimizing risk associated with designing wideband RF signal processing systems. Read More
IF subsystem-on-a-chip, AD6676, uses programmable continuous-time bandpass sigma delta ADC technology to digitize IF signals from 70–450 MHz. Single-chip solution can reduce complexity of receiver designs while promoting frequency planning flexibility and optimal instantaneous dynamic range. Implementation in deep sub-micron CMOS allows oversampling by providing digitized bandwidth of up to 160 MHz, and combination of features enables reconfigurable radio architectures. Read More
Optimized for input sampling rates up to 1 MHz, Model ADA2200 enables demodulation of signal input bandwidths to 30 kHz and achieves 0.009° phase detection sensitivity. Sampled Analog Technology uses charge sharing among capacitors to perform digital-like computations in analog domain. With configurable analog filter, designers of portable instrumentation can maximize battery life and perform precision magnitude and phase measurements on analog signals in presence of large noise sources. Read More
Integrating custom mixed-signal signal conditioning IC and sensing element based on Anisotropic Magneto-Resistive technology, Model ADA4571 provides direct, non-contact measurement of shaft position in brushless DC motors, minimizing noise and optimizing motor smoothness and torque. Device enables high-speed motor operation up to 50,000 rpm with 2 µs phase delay and low angular error of 0.5° max. Running on 2.7–5.5 V supply, sensor consumes 6.5 mA of power, and includes low-power sleep mode. Read More
Supplied in 32-lead LFCSP, AD2410 Automotive Audio Bus (A²B) transceiver promotes vehicle fuel efficiency by reducing weight of existing cable harnesses. Digital bus technology distributes high fidelity audio and control data, together with clock and power, over one UTP wire. Transceiver provides 50 Mbps of data bandwidth and support for up to 32 discrete upstream and downstream audio channels. Daisy chaining is supported, and system delay is fully deterministic at all slave nodes. Read More
Intended for use in single-carrier satellite communications, 5.72 x 4.51 x 1.63 in. HMC7053 block upconverter and 5.0 x 4.51 x 1.145 in. HMC7054 high-power amplifier (HPA) operate in 29–31 GHz frequency output range and feature -60 dBc SFDR performance. Ka-band block upconverter features 1–2 GHz dual input IF at 0 dBm typ and 20 dB conversion gain. Ka-band HPA achieves linear output power of 37 dBm, offers 42 dB small signal gain, and operates at 5 V while drawing 14 A. Read More
Enabling support of E-band (71–76 GHz, 81–86 GHz) frequencies, 16-bit AD9136 and 11-bit AD9135 suit telecom system manufacturers requiring microwave frequencies in point-to-point wireless backhaul equipment. Max sample rate of 2.8 GSPS allows multicarrier generation up to Nyquist frequency. Supporting complex input data rates up to 2.12 GSPS per D/A converter using 8-lane, 10.6 Gbps JESD204B interface, products achieve better than -80 dBc SFDR and offer noise performance of -163 dBm/Hz. Read More
Based on iCoupler® digital isolator technology, ADuM315x SPIsolator™ Series features low propagation delay and jitter in CLK, MO-SI, MI-SO, and SS channels to support SPI clock rates up to 40 MHz. Family has 3.75 kVrms isolation rating and also supports maximum sample rate for select ADI 12-, 16-, and 18-bit precision A/D converters. Housed in 20-lead SSOP package, isolators are suited for distributed control systems, PLCs, and sensor monitors. Read More
Other Company News from
Analog Devices, Inc.