Power / Signal Splitters

Dual Screen Splitter functions as video wall processor.
Power / Signal Splitters

Dual Screen Splitter functions as video wall processor.

Model SPLITMUX-SVDVI-2 allows users to simultaneously display and monitor video signals from 2 different computers or video sources on single screen. Combining functions of video wall processor, video scaler, PiP generator, and audio/video switch, device supports resolutions up to 1,900 x 1,200 and can de-interlace 1080i to 1080p. Controllable via IR remote control, front panel interface, or...

Read More »
PoE Splitter delivers up to 14 W of power.
Power / Signal Splitters

PoE Splitter delivers up to 14 W of power.

Suited for wireless network and IP applications, Series PSD14 DC-DC Power-over-Ethernet Splitter mounts next to Ethernet device, and is fully compliant with IEEE 802.3af standards. Input voltage is 36-56 Vdc and output voltage is 12, 5, or 3.3 V, depending upon model. Measuring 3.7 x 2.0 x 1.2 in., device is available in non-vented case with 10Base-T, 100Base-T, and 1000Base-T data rates. It is...

Read More »
Power / Signal Splitters

Ceramic Substrates reduce in-circuit transmission line losses.

Available in 0.010, 0.015, and 0.025 in. thicknesses, polished ceramic substrates provide approximately 0.2 dB improvement in line loss per inch on 0.025 in. thick alumina transmission line. Allowing for smaller circuit and element geometries, as well as reduced circuit size, substrates are suitable for use in routers and switches, servers, computers, wireless applications, RF and microwave...

Read More »
Power / Signal Splitters

Port Splitter expands communications capabilities.

Used with existing controllers, RS-232/DF1 port splitter connects to DF1 full-duplex port to allow simultaneous communication with local network and operator interface. Control users with one DF1 full-duplex port can use splitter to create one full-­function port for 2-way communication between controller and local network. Primarily designed to run programming terminal or HMI, second port is...

Read More »
Isolators protect process equipment and power input devices.
Power / Signal Splitters

Isolators protect process equipment and power input devices.

AC/DC-powered 630T Series isolators and signal splitters feature internal excitation supply to drive up to two 2-wire transmitters or other input loop devices. Multi-channel isolators provide space-efficient solution to eliminate ground loops, filter signal noise, and block high voltage surges. Measuring 1 in. wide, single/dual-channel isolators receive 4-20 mA inputs and provide fully isolated...

Read More »
Video Splitter is suited for industrial environments.
Power / Signal Splitters

Video Splitter is suited for industrial environments.

Based on Camera Link interface standard, CLV-401 Camera Link Video Splitter interfaces one Camera Link camera to 2 frame grabbers using Camera Link cables. Arrangement enables addition of second frame grabber for functions such as camera setup, secondary/parallel processing, and monitoring. First frame grabber acts as master, providing control and communications to camera, while secondary frame...

Read More »
Line Splitter allows testing of loads up to 1,800 W.
Power / Signal Splitters

Line Splitter allows testing of loads up to 1,800 W.

Meterman® ELS2 AC Line Splitter works with any ac current clamp or clamp meter to measure residential current without splitting ac line cords. Rated for 120 V at 15 A, unit provides 10 times current magnifying loop for accurately measuring low current. Built-in jacks are provided for voltage sag testing. Splitter includes nylon carrying case and is useful to residential, commercial, and...

Read More »
Splitter/Combiner Module suits RF test applications.
Power / Signal Splitters

Splitter/Combiner Module suits RF test applications.

Model SMP6905 incorporates six 2-way 0°, 10 MHz-1 GHz power splitters/combiners in high-density, double-wide SMIPII(TM) module. When used as splitter, it delivers 2 outputs of equal amplitude with 0° phase relationship between 2 output signals. Module can be used as combiner by applying each signal into output ports and vector sum will appear as single output. Model SMP6905 can be combined with...

Read More »

All Topics