Limiters

Non-Incendive Barrier Modules prevent explosions.
Miscellaneous Suppressors

Non-Incendive Barrier Modules prevent explosions.

While PI/NI-2D/24 protects 24 V digital signals in case of short circuit or over-voltage condition, PI/NI-2I/I limits max short circuit current to 24 mA in 4-20 mA loops and can be installed with 2-wire 4-20 mA transmitters. Both use current and voltage limiting circuitry to minimize risk of ignition in hazardous Class I, Division 2 or Zone 2 environments. Analog and digital signal modules have 2...

Read More »
Track Current Limiter is available in 4 models.
Limiters

Track Current Limiter is available in 4 models.

Compliant with California Title 24 and ASHRAE 90.1 requirements, Track Current Limiter ensures that track installations meet wattage limitations according to size and usage of space. It can be mounted as standard canopy, used in place of I connector, or as live-end. Unit's circuit breaker will trip and shut down power to track when track is overloaded, and device may be reset when overall total...

Read More »
Miscellaneous Protectors

Overcurrent Protection Device measures only .063 x .032 in.

Available in 4 hold current/maximum voltage ranges, including 0.10 A/15 Vdc, 0.20 A/9 Vdc, 0.25 A/9 Vdc, and 0.35 A/6 Vdc, Series 0603L Polyfuse® PPTC (polymer positive temperature coefficient thermistor) resettable over-current protection device has maximum fault current rating of 40 A, and meets TUV and UL safety standard certification. It is suited for wide range of consumer electronic...

Read More »
UL-Listed Cable Limiters help maintain system operation.
Limiters

UL-Listed Cable Limiters help maintain system operation.

CP 600 Cable Limiters isolate damaged conductors that have experienced faults due to short circuit incidents that may have occurred from splicing or insulation breakdowns and then safeguard remaining cables to keep systems operational. Available for cable sizes from 2 AWG to 1,000 kcmil, these 600 Vac products are offered in 7 terminal variations and interrupt faults up to 200 kA to protect...

Read More »
Limiters

SPIROL Announces Redesign of Brass Compression Limiter Line

Danielson, CT - SPIROL has redesigned the Series CL101 and CL111 Brass Compression Limiter line to significantly reduce cost. The original brass line was introduced by SPIROL in the 1990's during the time when companies started converting many metal assemblies over to plastic. The initial version of the Brass Compression Limiter line was designed with a thick wall to prevent the plastic from...

Read More »
Limiters

Compression Limiters absorb load in plastic assemblies.

Series CL500 roll-formed, insert-moldable Compression Limiters is designed around standard clearances for 6 and 8 mm bolts, while series CL550 is designed with additional clearance around bolts to accommodate greater positional tolerances. Standard material is low carbon steel with trivalent, hexavalent-free zinc plate finish for corrosion protection. They are used to preserve threaded joint's...

Read More »
Limiters

Current Limiter tracks maximum wattage allowances.

Available in maximum wattages of 120, 300, 600, and 900 W, ArchiTrak Current Limited Device (AKTCLC) acts as circuit breaker and trips power off should track be lamped beyond maximum lighting load. Tamper-resistant screws prevent altering or damaging of original lighting design. Canopy consists of steel backplate, designed to fit standard 4 in. square or octagonal j-box, and injection-molded...

Read More »
Limiters

Segment Protectors limit current in fieldbus networks.

Featuring trunk in/trunk out wiring T-connector, R2 FieldConnex® Segment Protectors can be disconnected while leaving trunk communications uninterrupted, and inherently prevent over-termination that can cause start-up and commission problems. Units provide IP20 protection with DIN rail mounting in 4, 6, 8, 10, and 12 spur configurations. They include removable terminals with retaining...

Read More »
Solid State Relays

Technologies Announces Series of First-to-Market Microwave Test Accessories for Communications, Aerospace/Defense Industries

SANTA CLARA, Calif., Jan. 2, 2007 -- Agilent Technologies Inc. (NYSE: A) today introduced a series of first-to-market, broadband microwave test accessories specifically optimized for communications and aerospace/defense applications. The innovations embedded in this industry-leading series provide broadband capability and enhanced measurement accuracy, which significantly expand the test and...

Read More »
Flow Limiter allows setting of maximum flow rate.
Limiters

Flow Limiter allows setting of maximum flow rate.

Welding Gas Flow Limiter allows maximum permissible gas flow levels to be set on flowmeters/regulators employed in cylinder shielding or pipeline gas supply. Once desired maximum flow rate is set, flow rate limiter clamps over flow control knob by tightening set screw thereby preventing increases from desired level. Welders can reduce flow from that predetermined level as application dictates....

Read More »

All Topics