Wall Perimeter Sealer facilitates cove applications.
Press Release Summary:
Featuring 100% solids formulation, chemical-resistant Superior Cove Kit is designed for vertical application at floor-wall joints to produce sanitary perimeter seal. This structural epoxy mortar, packaged in pre-measured kits to cover 35 lineal feet (4 in. vertical and 2 ft horizontal at 1/8 in.), requires clean surface prepared via sand blasting, water blasting, or other mechanical means. Each kit contains binder and blended aggregate in plastic mixing container.
Original Press Release:
Superior Cove Kit
Superior Cove Kit has been developed as a companion product to SUPERIOR SUPERTOP for easy application of coves at floor-wall joints. SUPERIOR COVE KIT is a structural epoxy mortar for vertical application to produce a sanitary perimeter seal.
SUPERIOR COVE KITS are packaged in pre-measured kits to cover 35 lineal feet @ 4" vertical, 2' HORIZONTAL @ 1/8".
For additional information or samples, use link provided, or call 800-240-1310
PRE-MEASURED EPOXY/WALL PERIMETER SEALER
DESCRIPTION:
SUPERIOR COVE KIT is a structural epoxy mortar designed for vertical application at floor-wall joints to produce a sanitary perimeter seal.
USES:
Form cove base
Provide a sanitary perimeter seal
Provide floor-wall joints chemical resistance
ADVANTAGES:
Easy to use pre-measured kits
100% solids- no shrinkage
Excellent chemical resistance
Seamless and easily cleaned
SURFACE PREPARATION:
Surface must be clean, sound dry and free of any oils, grease, curing compounds, dust, laitance or any other contaminants. This may be accomplished by sand blasting, water blasting or some other mechanical means. New concrete surfaces should be acid etched with SUPERIOR SAFETY ETCH and rinsed thoroughly. Surface may be dry or damp, but must be free of standing water. Apply SUPERIOR PRIMER 171 at 200 sq.ft/gal by brush or short nap roller.
MIXING AND APPLICATION:
1. Pour contents of Binder part A and Part B into empty pail and mix thoroughly with spatula or a slow speed ½" drill with paddle.
2. Add aggregate slowly, while mixing, to the mixed binder.
3. Mix until aggregate is thoroughly wet, approximately 2 minutes.
4. Apply to primed surface with cove trowel while primer is still tacky. If primer cures before application of cove mix, re-apply.
CLEAN UP:
Clean tools and equipment immediately with a suitable solvent such as Xylene or lacquer thinner.
PACKAGING:
Kit contains binder and blended aggregate in plastic 3 gallon mixing container. Kit covers 17.5 square feet @ 1/8". (35 lineal feet @ 4"vertical, 2" horizontal @ 1/8")
CAUTION:
For professional use only. Epoxy systems can cause delayed dermatitis. Avoid prolonged contact with skin. See Material Data Sheet for proper handling and required safety equipment.
DISCLAIMER:
All recommendations, technical data and test data contained in this brochure are based upon the results of controlled laboratory tests or in actual field tests However, SUPERIOR EPOXIES & COATINGS, INC. makes no warranty of any kind concerning this data. Due to variance in storage, handling and applications of these materials, SUPERIOR EPOXIES & COATINGS accepts no liability for the results obtained. It is suggested that potential users try small applications to determine the suitability of each individual product for their specific requirements..
