Sampling Conditioner removes moisture at sampling point.

Press Release Summary:

Available with E Instruments portable emissions analyzers, Sample Conditioning Unit mounts directly at sampling probe exit before sampling hose. Functionality minimizes NOx and SOx loss from condensation and fosters accurate NO2 and SO2 measurements below 10 ppm.

Original Press Release:

NEW Sampling Conditioning Unit; Efficient Solution to Immediately Remove Moisture at the Sampling Point

• Minimize NOx & SOx Loss from Condensation

• Allows Accurate Low NO2 & SO2 Measurements Below 10 ppm

• Available with All E Instruments’ Portable Emissions Analyzers


The accurate emissions monitoring of soluble gases, present in flue gas from industrial and commercial processes, requires a sampling system designed to prevent significant loses of the SO2 and/or NO2 gases in the sampling lines prior to entering the analyzer or measuring device. The measured readings could be in excess of 20% lower than the actual values in the process.


E Instruments has designed a Sample Conditioning Unit mounted right at the sampling probe exit before the sampling hose, where the water can rapidly condense and separate immediately from the gas therefore minimizing any contact of the target gases with the liquid water.

E Instruments International

402 Middletown Blvd.

Suite 216

Langhorne, PA 19047

Phone: 215-750-1212

Fax: 215-750-1399



More from Architectural & Civil Engineering Products

All Topics