Machinable Clamps suit VMC and HMC applications.

Press Release Summary:




Available in 10 sizes ranging from .160-4.050., ID Xpansion Clamp is made of mild steel. Machinable and used to hold lathe parts from internal diameter, clamp offers concentricity of .0005 that can be held because clamp is machined to match individual workpiece. Flange diameter is held to close tolerance for precision mounting of multiple parts on workcube or fixture plate, and, once machined, low profile clamps are tightened with hex key or hydraulic pull cylinder.




Original Press Release:



ID Xpansion Clamps



Mitee-Bite introduces the new ID Xpansion Clamp for VMC and HMC applications. This mild steel, machinable clamp is the ideal way to hold lathe parts from an internal diameter. Concentricity of .0005 can be held because the clamp is machined to match the individual workpiece.

Produced in ten sizes they have a full range from .160 to 4.050. Typically, these clamps can be remachined and used for smaller parts.

The flange diameter is held to a close tolerance for precision mounting of multiple parts on a workcube or fixture plate. Once machined, these low profile clamps can be tightened with a hex key or hydraulic pull cylinder. The screw, with the tapered head, goes through the clamp and mounts directly into the fixture plate or pull cylinder for additional rigidity.

Contact Mitee-Bite Products Inc. for More Information, www.miteebite.com
or 800-543-3580.

All Topics