Gasoline Additive helps vehicles pass emissions tests.
Share:
Press Release Summary:
As concentrated detergent, AMSOIL P.I. cleans combustion chamber deposits, intake valve deposits, and port fuel injector deposits, eliminating need for fuel injector cleaning procedures. It also helps maintain peak engine efficiency in low mileage engines. By treating one full tank of gas every 4,000 miles or 100 hr of service, additive helps improve fuel mileage while minimizing emissions and noise from carbon rap and pre-ignition.
Original Press Release:
Restore Power and Performance with Newly Reformulated AMSOIL P.I. Gasoline Additive
March 6, 2007
Newly reformulated AMSOIL P.I. (Performance Improver) provides unsurpassed fuel economy and performance. Today's fuels vary in quality and additive treat levels. Although a certain level of detergent additive is required by law to be formulated into gasoline, cost restrictions cause refineries to use low quality additives in the lowest additive concentration (LAC), a level insufficient to prevent deposit accumulation. As a result, deposits accumulate on fuel injectors, intake valves and combustion chambers, often within just a few thousand miles, disrupting spray patterns, affecting electronic sensors and causing a multitude of problems.
The newly formulated AMSOIL P.I. Performance Improver is the most potent gasoline additive available today. As a concentrated detergent, it is unsurpassed in cleaning combustion chamber deposits, intake valve deposits and port fuel injector deposits, eliminating the need for expensive fuel injector cleaning procedures. The product is ideal for use prior to emissions inspections. It also helps maintain peak engine efficiency, fuel economy, power and drivability in newer low mileage engines. In engines with accumulated deposits, testing showed AMSOIL P.I. provided the following clean-up benefits after only one tank of gasoline:
o Improves fuel mileage an average of 2.3% and up to 5.7%
o Reduced emissions
~ hydrocarbons (HC) up to 15%
~ carbon monoxide (CO) up to 26%
~ nitrous oxides (NOx) up to 17%
o Restored power and performance
o Reduced need for costly higher octane fuel
o Reduced noise from carbon rap and pre-ignition
o Better drivability
o Smoother operation
Usage Recommendations: Treat one full tank of gas every 4,000 miles or 100 hours of service. One bottle treats 20 gallons of gas. Do not treat and run more than 40 gallons of gas per treatment. P.I. helps pass emissions tests. Treat gas, run that tank and fill up again prior to test. Safe for use with catalytic converters, oxygen sensors, oxygenated gas and 10% ethanol blended gas. Ideally, P.I. should be poured into the tank prior to filling it up with gas, but it will mix thoroughly when added after fill-up through normal agitation from driving.
Note from SBS Synthetic Oil, LLC: SBS Synthetic Oil is a distributor of Amsoil products. Please contact SBS Synthetic Oil with questions or orders. Amsoil products can be purchased from Amsoil distributors. Commercial and Retail pricing available for business's.
