Applicator helps apply liquid no-clean fluxes.
Press Release Summary:
Suited for use in tiny chip components and individual solder joints, Cobrush flux applicator features fine bristle tip that helps application in small areas of densely populated assemblies. Constructed of rugged polypropylene, applicator has transparent cartridge that allows user to see amount of remaining material in reservoir and snug-fitting cap to prevent flux evaporation in barrel.
Original Press Release:
Easy to Use 'Cobrush' Applies Liquid Flux Like an Artist's Brush
October 6, 2006
Londonderry, New Hampshire, USA -- Cobar Solder Products' new Cobrush flux applicator puts flux where it's needed - in just the right amount - and is ideal for applying liquid no-clean fluxes to any site that needs to be soldered. Cobrush is a precise, inexpensive, handy tool for applying liquid flux to tiny chip components and individual solder joints. It's disposable, and compatible with many different types of fluxes. Its fine bristle tip allows the user to apply flux to very small areas in densely populated assemblies. This inexpensive applicator cuts down on waste and prevents over-fluxing, this reducing possible cleaning time and preventing contamination.
The Cobrush's transparent cartridge allows the user to see the amount of remaining material in the reservoir; its small, compact size and large capacity make it ideal for most rework and post-assembly applications. Flux is dispensed by lightly squeezing the barrel, then using the gentle applicator bristles to apply the flux, just like an artist's brush; the user controls the amount of flux flow. A snug-fitting cap prevents flux evaporation in the barrel, thus extending the life and purity of the flux. Constructed of rugged polypropylene, the Cobrush features an ergonomic design for ease of use, and is compact enough to fit into the top pocket of a lab coat and can easily be labeled.
Cobar Solder Products is the U.S. subsidiary of the Cobar Group, a leading global supplier of solder pastes, fluxes, and other electronics soldering materials for electronics assembly. Cobar BV, founded in 1983 in Holland, is the technological center and headquarters of the Cobar Group. Cobar BV has been certified to ISO/TS 16949:2002; the company was accredited to ISO 9001 in 1994 and to ISO 14001 in 1997, and is also accredited to NATO's AQAP-110.
Contact the company at
Aluminiumstraat 2, 4823
AL Breda, Holland, or
PO Box 3251, 4800 DG Breda,
Holland
Tel +31 (0)76 544 5566.
Cobar Solder Products is located at
53 Wentworth Avenue,
Londonderry, New Hampshire 03053 USA
Tel. (603) 432-7500
Fax (603) 432-7519
For more information, visit www.cobar.com.
