Mold Craft, Inc. Builds Micro Mold to Show in Sodick Plustech's New Micro Molding Machine at NPE2012


Mold Craft Inc. (booth 1295) will showcase a 4 - cavity mold for very small PEEK parts at NPE2012. The pipette "funnel tip" component for a medical customer of Mold Craft's will run in the new Sodick Plustech LP20EH2 Micro Molding series with a 12-mm diameter plunger. Sodick's booth is #363.

The funnel tip, which was molded of PEEK, has a minimum thin wall section of 0.008 inch. Designed and built by Mold Craft, the tool incorporates the patented MeltFilpper technology from Beaumont Technologies. The part is .472 inches long by .054 inch at the top of the funnel tip.

According to Jim Liddell, New Business Development Manager for Mold Craft, the mold started out as a single-cavity tool designed in a larger mold base to accommodate expansion. "To prove out the design, Sodick ran the mold and it worked well, so due to demand we expanded the mold to four cavities," he states. "Eventually, the mold could be an 8-cavity tool, dependent on customer production demand."

Mold Craft worked with Beaumont Technologies to verify the mold design using Beaumont's proprietary VeriFlo mold-filling analysis software. Melt Flipper was used in the mold because there was concern about the material flow and being able to fill the cavities evenly using PEEK material. "The mold-filling analysis revealed a number of negative effects from shear," notes Liddell. "The MeltFlipper technology eliminated those concerns."

A mold manufacturer that typically specializes in high-cavitation production molds for the medical disposable, medical device, and consumer product markets, Mold Craft also creates MIM molds for a variety of industries. Come to NPE to see this mold in production at booth 363 and 1295.

For More Information about this article please contact:

Jim Liddell

Sales & Marketing Manager

Mold Craft, Inc.

200 Stillwater Road

Willernie, MN 55090

jaliddell@mold-craft.com

Ph: 651 426-3216

Cell: 612 281-8851

Fax: 651 426-9472

www.mold-craft.com

More from Controls & Controllers

All Topics