STRATFORD, Conn. â€“ What if a contractor pulled datacom wire for a ten-story building but had neglected to install the required bushings for each floorâ€™s electrical enclosures? Sounds like a lot of time and money would have been wasted, right? Not if there was a perfect solution.
Thankfully, the electricianâ€™s distributor remembered his training session with a member of Bridgeportâ€™s â€śTeam Done Thatâ€ť that dealt with just such a predicament. The distributorâ€™s solution for the contractor was Bridgeportâ€™s SB-386NM -- a split, insulated, plastic bushing used where wires have already been pulled through Rigid/IMC conduit or EMT fittings. â€śThe Bridgeport solution saved everyone a ton of time and money,â€ť remarked Rob Riley, the â€śTeam Done Thatâ€ť licensed instructor.
Bridgeportâ€™s Mighty-Rite® Nonmetallic Split Bushings have a durable snap-on, hinged design that adjusts and aligns easier, even in tight spots, requiring no installation tools. The bushingâ€™s unique, self-aligning latching mechanism also allows one-hand installation, so the contractor can move onto to the next job faster. The bushings are internally threaded for use with either threaded conduit or conduit fittings.
Mighty-Rite cULus Listed Nonmetallic Split Bushings are part of Bridgeportâ€™s full range of electrical solutions that can be found in the â€śWall of Orangeâ„˘â€ť â€“ a completely stocked selection of quality electrical fittings and innovative product solutions available from major electrical distributorships across the U.S. and Canada.
For more information about Bridgeportâ€™s solutions that help contractors become more productive on the job site, contact: Bridgeport Fittings, Inc., 705 Lordship Blvd., Stratford, CT 06615; Tel: (203) 377-5944; Fax: (203) 381-3488; or visit Bridgeportâ€™s Website at http://www.bptfittings.com.
Media contact: Harry McBrien, Maier True Communication, (860) 470-3127; firstname.lastname@example.org