Presetting Tool is made from carbon steel.
April 7, 2010 -
Available in sizes of 5/8 in. and up, presetting tool is used to preset ferrules on tubing prior to final assembly into fitting. It is suited for instrumentation tube fitting installations in tight spaces or hard-to-work areas.
(Archive News Story - Products mentioned in this Archive News Story may or may not be available from the manufacturer.)
Original Press release
Brennan Industries, Inc.
6701 Cochran Rd.
Cleveland, OH, 44139
USA
Brennan Industries Introduces New Presetting Tool for Instrumentation Tube Fitting Installations in Tight, Awkward Spaces
CLEVELAND - Brennan Industries Inc., a leading international supplier of hydraulic fittings and adapters, introduces the new presetting tool used to preset ferrules on tubing prior to final assembly into a fitting. The presetting tool is ideal when an installation must be made in tight spaces or hard-to-work areas.
Manufactured from carbon steel, the Brennan presetting tools for instrumentation tube fittings are available in sizes 5/8 inches and up.
"The presetting tool lets major portions of installation work happen in a more favorable work setting because it allows for the presetting of the ferrules onto the tubing in a safe, open and ground level area," said Bill Jarrell, vice president of marketing at Brennan. "Users that have installations in cramped areas or overhead will benefit from our preset tool."
To use the preset tool, the user must secure the tool in a vise, remove the protective nut and assemble the fitting nut and ferrules loosely onto the tool then insert the tubing through the nut and ferrules until it bottoms in the preset tool.
After standard assembly procedures have been followed, the tubing with the nut and ferrules can be removed from the body of the preset tool and attached to the tube fitting body by following standard reassembly instructions.
About Brennan Industries
Supplying a wide range of industries throughout the world, Brennan Industries offers more than 25,000 standard and special hydraulic fittings and adapters in sizes ranging from 1/8 to 2 ½ inches. These include a wide choice of fitting and adapter types such as tube, O-ring face seal, instrumentation, metric bite type, push-to-connect, conversion and flareless bite type. Brennan Industries also offers valves, clamps and swivels. Most products are available in carbon steel, stainless steel and brass, and meet or exceed J.I.C., S.A.E. and other specifications.
Brennan products are stocked at six strategically located, full-service distribution centers in: Atlanta, Cleveland, Dallas, Los Angeles, Seattle and Toronto.
|
|
|
|
|
|
|
|
