Pneumatic Chain Saw cuts underground pipe, minimizes excavation.
June 4, 2010 -
PowerGrit Air Chain Saw cuts up to 20 in. dia ductile and cast iron pipe, PVC pipe, HDPE pipe, and cured-in-place piping for utility, municipal, construction, and industrial applications. Allowing user to cut from one position, design promotes operator safety while reducing physical effort. Cutting from one side also reduces excavation requirements. Diamond segments grind material for reduced vibration and no kickback, and pneumatic power eliminates exhaust fumes.
(Archive News Story - Products mentioned in this Archive News Story may or may not be available from the manufacturer.)
Original Press release
CS Unitec, Inc.
22 Harbor Ave.
Norwalk, CT, 06850
USA
POWERGRIT Chain Saw Cuts Underground Pipe and Minimizes Excavation
CS Unitec's PowerGrit Air Chain Saw is ideal for utility, municipal, construction and industrial pipe cutting applications. Cutting ductile iron pipe, cast iron pipe, PVC pipe, HDPE pipe, and cured-in-place piping is now safer, faster and easier. It has a cutting capacity of up to 20" dia.
This saw offers significant advantages over conventional gasoline cut-off saws using abrasive blades. It increases operator safety, reduces physical effort and boosts productivity. The PowerGrit Air Chain Saw allows the user to cut from one position. Abrasive cut-off saws require the operator to maneuver the saw 360 degrees around the pipe. Cutting from one side reduces excavation for underground pipes. Special patented diamond segments grind rather than tear the material which reduces vibration and eliminates kickback. The result is a precise, clean cut in less time.
Additionally, pneumatic power eliminates the exhaust fumes associated with conventional saws, especially in confined spaces. This CS Unitec saw requires minimal excavation when cutting underground utility pipes, saving time and budget expenses. Maintenance for the pneumatic saw is minimal, as there are no belts, pistons, gas fuel lines or carburetors to service.
Available with 15" or 20" bar lengths, the PowerGrit diamond chain saw can be used hand-held to cut pipe up to 20". It cuts wet with water lubricating bars. Typically 3 or 4 gallons of water are sufficient for one cut of an 8" diameter ductile iron pipe. Options include a pipe clamp with up to 12" capacity.
For more information on this time-saving air utility saw, please contact CS Unitec by phone at (800) 700-5919 or (203) 853-9522, by fax at (203) 853-9921; or by email at info@csunitec.com.
The PowerGrit Saw is also featured on the company's website: http://www.csunitec.com/concrete-saws...
www.csunitec.com
info@csunitec.com
|
|
|
|
|
|
|
| 
