Deburring System features return-to-operator configuration.
March 4, 2009 -
Suited for applications requiring small footprint and portability, Tri-Ten series planetary head deburring system is designed to deburr both sides of part in single pass. Magnetic conveyor passes parts loaded at one end of system through offset planetary deburring head, where three fiber abrasive brushes deburr upward facing surface, after which part is carried to flipping mechanism and transported back through planetary head for deburring.
(Archive News Story - Products mentioned in this Archive News Story may or may not be available from the manufacturer.)
Original Press release
Abtex Corp.
89 Main St., P.O. Box 188
Dresden, NY, 14441-0188
USA
Abtex Introduces Tri-Ten Return-to-Operator System
Abtex Corporation has expanded its Tri-Ten planetary head deburring system to include a return-to-operator (RTO) configuration. The Tri-Ten series is designed to deburr both sides of a part in a single pass, and all previous systems had been flow-through configurations.
The new system is designed for applications requiring a small footprint and portability. Parts are loaded at one end and a magnetic conveyor passes them through an offset planetary deburring head where three Abtex fiber abrasive brushes deburr the upward facing surface. The conveyor then carries the part to a mechanism that flips it on to a parallel magnetized conveyor that transports the part back through the planetary head and deposits it at an opening next to the entrance.
The pictured system, which has wheels for portability, deburrs both sides of green powder metal parts. The part also has three half-inch protrusions on one side, so it first passes through a single long trim brush that extends beyond one the protrusions to deburr the target surface.
For information, call Abtex at 888.662.2839, e-mail sales@abtex.com or visit www.abtex.com. Abtex Corporation is at 89 Main Street, P.O. Box 188, Dresden, New York 14441. Telephone 315.536.7403, fax 315.536.0280.
|
|
|
|
|
|
|
| 
