Clamping and Machining System accommodates 5-sided parts.
August 25, 2010 -
Intended for use on horizontal machining centers, K-Column Modular Clamping and Machining System has 400 mm design and can hold raw blank material up to 3.5 in. wide x 14.5 in. high. It is capable of affording multiple or single part machining on pallet center and comes in 300, 500, and 600 mm pallet sizes. Utilization of raw material as actual work holding allows for 5-sided part machining, eliminating need to purchase sized blanks.
(Archive News Story - Products mentioned in this Archive News Story may or may not be available from the manufacturer.)
Original Press release
EB Manufacturing Co., Inc.
825 Middle St.
Middletown, CT, 06457
USA
New Modular Clamping and Machining System from EB Manufacturing Reduces Overall Part Costs
EB Manufacturing Company is introducing the "K-Column" Modular Clamping and Machining System for use on horizontal machining centers. The 400mm design has a capacity to hold raw blank material up to 3.5" wide x 14.5" high, which affords multiple or single part machining on the pallet center.
This system utilizes raw material as the actual work holding, allowing for five-sided part machining and eliminating the need to purchase sized blanks. Material costs, set-up times and cycle times, as well as programming times, are therefore greatly reduced.
In addition, the money saving "K-Column" is available in 300, 500 and 600mm pallet sizes.
Please contact EB Manufacturing Company for complete data on the "K-Column Modular Clamping and Machining System.
EB Manufacturing Co., Inc.
825 Middle Street
Middletown, CT 06457
P) 860-632-8563
F) 860-632-8601
W) www.ebmanufacturing.com
E) info@ebmanufacturing.com
|
|
|
|
|
|
|
| 
