Bevel Gearboxes transmit up to 6,600 Nm.
Bevel Gearboxes transmit up to 6,600 Nm. |
|
|
January 17, 2006 -
Featuring Gleason gearing, PowerGear Models 360 and 450 measure 360 mm³ and 450 mm³ with 75 mm and 90 mm diameter drive shafts and torque transmission of 3,750 and 6,600 Nm, respectively. Both lubricated-for-life units are available with 6 gear ratios up to 5:1 and each design has solid and hollow shaft variants with up to 4-way shaft configurations. Fretting-free torque transfer is provided using friction locked fit between shaft and bevel gear.
(Archive News Story - Products mentioned in this Archive News Story may or may not be available from the manufacturer.)
Original Press release
Power Jacks Limited
Maconochie Road
Fraserburgh, Aberdeenshire, , AB43 8TE
United Kingdom
New P360 & P450 Bevel Gearboxes from Neeter Drive Transmit up to 6600Nm
Neeter Drive has extended the PowerGear range of bevel gearboxes with the introduction of two new sizes. The new "size 360 and 450" gearboxes are designed to offer the same high torque characteristics of the other PowerGear units but in two much larger sizes. They extend the torque transmission of the range up to 3750Nm for the size 360 and 6600Nm for the size 450. This now means the range has extended its torque capability by a further 3400Nm. These high torque ratings were achieved from parameter optimised Gleason gearing. This is complimented by uniform load distribution on the gear teeth that is set by optimising the contact pattern during assembly.
The main body of each unit is as per its size designation 360mm and 450mm cubed with 75mm and 90mm diameter drive shafts respectively. Both gearboxes are available with six gear ratios up to 5:1 as standard and each design has solid and hollow shaft variants with up to 4-way shaft configurations.
The units' design gives the following advantages:
The high industrial efficiency of the gearbox, 98%, saves energy costs.
The compact and rigid design assures highest performance in a small footprint.
Fretting-free torque transfer using a friction locked fit between shaft and bevel gear.
Lubricated for life, the gearboxes are, depending on their size, maintenance free, if operated under normal conditions.
Typical applications for the PowerGear are angular torque transfer and torque distribution in single, or multiple shaft configurations. In non-stationary applications where weight is extremely important, the PowerGear design is the ideal solution.
For further information on the New PowerGear bevel gearboxes or any of our other products, please contact us on +44 (0) 1346 513131 or browse our website where catalogues, datasheets and drawings can be downloaded.
Power Jacks Group
Maconochie Road , Fraserburgh
Aberdeenshire AB43 8TE
Scotland (UK)
Tel: +44 (0) 1346 513131
Fax: +44 (0) 1346 516827
Email: sales@powerjacks.com
|
|
|
|
|
|
|
|
|
|
| 
