Company News

Texas Instruments Incorporated

12500 TI Boulevard, Dallas, TX, 75243, USA

  • 972-995-2011

Latest New Product News from
Texas Instruments Incorporated

Controls & Controllers

LM5170-Q1 DC/DC Current Controller uses average current-mode control method.

March 23, 2017

Delivering more than 97% efficiency with 99% accuracy in monitoring, LM5170-Q1 DC/DC Current Controller is equipped with 5-A peak half-bridge gate drivers. Housed in 48-pin, 9mm x 9mm quad flat package, unit prevents negative current using diode emulation mode of rectifier MOSFETs.

Read More

Electrical Equipment & Systems, Test & Measuring Instruments

DAC8775 Converter's Design is thermally optimized.

March 11, 2017

Operated from 12V to 36V power rail, 16-bit DAC8775 Digital to Analog Converter comes with smart alarms to monitor open load, short circuit, over-temperature, CRC and watchdog timer diagonostic features. Offering 0.1% full-scale deflection in -40°C to 125°C temperature range, DAC8775 is housed in 10 mm x10 mm quad-flat no-lead (QFN) package.

Read More

Computer Hardware & Peripherals, Controls & Controllers

SimpleLink™ Wireless MCUs come with single-chip hardware.

January 21, 2017

Featuring Bluetooth-compliant radio and low-power sensor controller, SimpleLink CC2640R2F and CC2640R2F-Q1 Wireless MCUs are used in building, medical, commercial and industrial automation. Enabling smartphone connectivity for car access, CC2640R2F-Q1 wireless MCU comes in 7x7 mm QFN package and provides PEPS and RKE. Housed in 2.7 x 2.7 mm, 4 x 4 mm, 5 x 5 mm and 7 x 7 mm QFN packages,... Read More

Mechanical Power Transmission

Current-Sense Amplifier with enhanced PWM rejection.

November 13, 2016

Used in motor control, solenoid control and power delivery systems, Current-Sense Amplifiers boosts overall motor efficiency. With low offset voltage at 5 µV, offset drift at 50 nV/°C, gain error at 0.05 % and drift performance at 0.5 ppm/°C, device provides good AC CMRR of 93 dB at 50 kHz. Enables voltage at 80V and negative voltage at -4V induced by the inductive kickback of the motor,... Read More

Electronic Components & Devices

Quad Deserializer Hub supports driver assistance systems.

October 20, 2016

Compliant with MIPI CSI-2 specification, Model DS90UB964-Q1 with FPD-Link III interface simultaneously aggregates and replicates data from up to 4 cameras in automotive and radar applications. Dual outputs with virtual channel ID mapping and port replication save processor resources to speed processing of data from cameras at 100 MHz per sensor and 12-bit resolution. Adaptive equalization... Read More

Electrical Equipment & Systems, Electronic Components & Devices

DC/DC Buck Converter offers DDR memory power solution.

October 5, 2016

With 2.95–6 V input, Model TPS54116-Q1 offers power management solution for DDR2, DDR3, and DDR3L memory subsystems in automotive and industrial applications. Integrated low- and high-side power MOSFETs and 1 A peak sink/source DDR VTT termination regulator support 4 A of continuous output current. Supplied in 4 x 4 x 0.75 mm WQFN package, synchronous step-down converter provides up to 2.5 MHz... Read More

Computer Hardware & Peripherals, Controls & Controllers

Wireless Microcontroller offers dual-band connectivity.

September 19, 2016

Expanding functionality of IoT networks, SimpleLink™ CC1350 combines Sub-1 GHz transceiver and Bluetooth low energy radio, as well as ARM® Cortex®-M3 core in single, Flash-based, 4 x 4 mm QFN package. Device offers range up to 20 km on coin cell battery for building and factory automation, alarm and security, smart grid, asset tracking, and wireless sensor network applications. Sleep... Read More

Electrical Equipment & Systems

Differential Inductive Switch delivers accuracy and reliability.

August 24, 2016

Using coil drawn on PCB, LDC0851 detects presence or absence of conductive material. Magnet-less operation simplifies implementation, and design is immune to nonconductive contaminants, such as oil, dirt, and dust. Suited for proximity, position, and motion sensing applications, such as rotational encoders, buttons, and door open/close detection, switch does not require any calibration during... Read More

Electrical Equipment & Systems, Electronic Components & Devices, Optics & Photonics

WPC v1.2, Qi-Certified Transmitter wirelessly delivers up to 15 W.

July 28, 2016

Supplied in 9 x 9 mm VQFN package, bq501210 enables connectorless models of industrial and medical equipment. Fixed-frequency solution, which enables 84% system efficiency with minimal thermal dissipation and EMI, supports multiple fast-charging protocols and can reduce end-application size by eliminate need for bulky wiring. Rail control output provides power to deliver full 15 W... Read More

Electrical Equipment & Systems, Electronic Components & Devices

Isolated Gate Driver supports high-voltage applications.

July 20, 2016

Providing reinforced isolation of 5.7 kVrms, surge immunity up to 12.8 kV, and common-mode transient immunity >100 V/ns, Model UCC21520 is suitable for low-side, high-side, high-side/low-side, or half-bridge power management designs. Dual-channel device delivers propagation delay of 19 ns and channel-to-channel delay matching of <5 ns. Operating with 3–18 V input, driver features 4 A/6 A... Read More

Controls & Controllers, Electronic Components & Devices

DDR Memory-Termination Linear Regulator suits space applications.

July 12, 2016

Available in 16-pin dual-ceramic flat package, QML Class V and 100 krad (silicon) RHA qualified TPS7H3301-SP is immune to single-event effects up to 65 megaelectron volts per centimeter squared (MeV/cm²). This double-data-rate (DDR) memory linear regulator, which integrates 2 monolithic power FETs for source and sink termination and one internal voltage reference, has 0.16 in.² footprint.... Read More

Electronic Components & Devices, Mechanical Power Transmission

Reinforced Isolated Amplifier expands performance, lifespan.

June 30, 2016

Available in 5.85 x 7.5 mm SOIC package, AMC1301 helps engineers design accurate systems without having to compensate for DC and temperature drift errors. Offset drift is 3 µV/°C over -40 to +125°C range, and working breakdown voltage – 1,000 Vrms for insulation barrier lifetime of 64 years min – exceeds VDE0884-10 requirements. Used for shunt-based current sensing in... Read More

Controls & Controllers, Electronic Components & Devices

DC/DC Buck Regulators eliminate switch-node ringing.

June 29, 2016

By eliminating switch-node ringing, 2.5 A Model LM53625-Q1 and 3.5 A Model LM53635-Q1 lower noise and EMI emissions by up to 15 dB at system level. Wide operating range of 3.5–42 V handles start-stop and load-dump conditions for 12 V lead acid automotive batteries. Devices provide up to 93% efficiency at 2.1 MHz to support compact and high-temperature conditions in automotive applications.... Read More

Display & Presentation Equipment, Electronic Components & Devices

Low-Jitter Retimers resolve HDMI® 2.0 and MIPI® signal issues.

June 23, 2016

Enabling extended signal range over long traces, connectors, and cables without degradation, Low-Power Retimers optimize video and camera signal quality in PCs, mobile devices, HDTVs, and automotive infotainment systems. Models DP159 and TMDS181 include adaptive equalization up to 15 dB and support multi-gigabit signals, such as DisplayPort and HDMI, up to 6 Gbps. Model DPHY440 is a 4-by-1-Gbps... Read More

Electronic Components & Devices

N-Channel Power MOSFET maintains typical Rdson of 54 mOhm.

June 22, 2016

Offered in 1.53 x 0.77 mm silicon-based package, 60 V Model CSD18541F5 maintains typical on-resistance of 54 mΩ at 10 V gate-to-source, and is designed to replace standard small-signal MOSFETs in space-constrained industrial load-switch applications. LGA package features 0.5 mm pitch between pads for easy mounting and is 80% smaller than traditional 60 V load switches. Integrated ESD protection... Read More

Controls & Controllers, Electronic Components & Devices

Motor Drivers boost powertrain performance.

June 17, 2016

For powertrain applications, Model DRV8305-Q1 features programmable slew-rate control and operates down to 4.4 V to support start-stop functionality. Three-phase brushless DC gate driver operates from -40 to 150°C, meeting AEC-Q100 Grade 0 automotive specification. For design flexibility, 100 V Model UCC27211A-Q1 half-bridge gate driver supports brushed and brushless DC motor applications.... Read More

Electronic Components & Devices, Test & Measuring Instruments

Resolver-to-Digital Converter eliminates external circuitry.

June 13, 2016

With integrated power supply, exciter amplifier, and functional safety features, Model PGA411-Q1 supports 4 Vrms and 7 Vrms resolver sensors in automotive and industrial applications. Device is capable of simultaneously exciting resolver sensor coil and calculating angle and velocity of rotating motor shaft without external components. Integrated built-in self-test performs analog and logic... Read More

Electrical Equipment & Systems, Electronic Components & Devices

DC/DC Converter offers differential remote-voltage sensing.

June 2, 2016

Supplied in 5 x 7 x 1.5 mm PowerStack™ QFN package, 16 V(IN) SWIFT™ TPS458D22 features integrated 2.9/1.2 mΩ high-/low-side RDS(ON) power MOSFETs with 40 A continuous output current to drive ASICs and DSPs in space-constrained applications. Synchronous step-down converter employs D-CAP3™ control-mode topology, features 0.5% reference-voltage accuracy over temperature, and includes true... Read More

Electrical Equipment & Systems, Electronic Components & Devices

DC/DC Converter (12 V, 10 A, 10 MHz) achieves >50 A/cm³ density.

May 25, 2016

Supplied in 20-pin, 3.5 x 4 x 1 mm HotRod™ QFN package, TPS54A20 SWIFT™ synchronous DC/DC step-down converter features 14 nsec min on-time that allows for 4/7/10 MHz operation. Operation up to 5 MHz per phase is supported without special magnetics or compound semiconductors, which designers can use for 8–14 V input and 10 A output applications. Merging switched-capacitor circuit... Read More

Test & Measuring Instruments

Dual-Channel ADC provides direct RF sampling.

May 20, 2016

Supporting RF inputs up to 4 GHz, 14-bit Model ADC32RF45 enables direct RF signal conversion in first, second, and third Nyquist zones, minimizing filter complexity. Converter detects weakest signals with noise-spectral density of -155 dBFS/Hz, and offers signal-to-noise ratio of 58.5 dB at 1.8 GHz input frequency. With 3 GSPS max sample rate, ADC delivers instantaneous 1.5 GHz/channel bandwidth,... Read More

Other Company News from
Texas Instruments Incorporated

December 16, 2011

x x.

April 21, 2010

x x

October 28, 2009

x x

December 22, 2005

TI to Acquire Chipcon