New Transceivers Products

Data Radios offer point-to-multi-point wireless I/O.

DIN-rail mount RAD-DATA-BUS systems enable monitoring and control at low point count remote sites while eliminating need for PLC where local logic is not required. Each transceiver consists of master, slave, and store-and-forward repeater/slave. Data radios not only move RS-232, RS-422 and RS-485 for serial data from PLC or controller with MODBUS and Allen-Bradley DF1 protocols, but also allow...

Serial Infrared Transceiver has 3.1 x 6 mm footprint.

Suited for short-distance wireless communication, the TFBS4711 115 kbit/s transceiver measures 1.9 mm high and has 6-pin interface. Unit can be placed on either side of circuit board and enables designers to add short-range IR connectivity to handheld systems. SIR facilitates digital image and data file transfers from mobile phones and PDAs.

Radio Frequency Chip complies with IEEE 802.15.4 standard.

Model EM2420 combines transceiver with embedded networking software that can run on low-power microprocessors. It operates on 16 channels in 2.4 GHz ISM band with hardware-based, AES 128-bit encryption for secure communications. EmberNet networking protocol stack provides sending and receiving over low bitrate wireless networks. Unit is ZigBee ready and complies with 802.15.4 standard, which...

Wireless Module Transceivers have interference protection.

With XStream Interference Immunity(TM) (XII(TM)), transceivers' hardware and software feature set allows designers to create wireless systems immune to RF interferers. XII technology can block 60 dB of interference. Products also utilize frequency hopping spread spectrum communication that delivers additional protection against interference.

Whitepaper: 7 Trends for IoT in Hospitality

Check out this white paper to see how the IoT can be used in your hotel to reduce energy consumption, increase guest satisfaction, improve maintenance, and more.

Transceiver suits small, wireless applications.

Using proprietary FHSS technology, miniature 900 MHz AC4490-1x1(TM) measures 1 in.Ã-² and enables engineers to design-in full wireless capability. All components are integrated into multi-chip module design. Transceiver includes proprietary RF232(TM) embedded protocol for plug-and-play installation and TTL serial interface that provides bi-directional communication. With up to 115.2 Kbps...

Half Duplex RS485 Transceiver has 20 Mbps data rate.

Model SP1485E features typical transmitter and receiver skews of 2 and 5 ns and propagation delays of 20 and 30 ns respectively. Capable of driving up to 32 transceivers on one bus, it offers ESD protection of Ã-

Parallel Port Transceiver has power-on protection feature.

Low-voltage (3-3.6 V), high-speed transceiver IC model 74LVC161284TTR conforms to IEEE1284 parallel port interface standard, while model 74LVCZ161284ATTR also offers error-free power-up function. Each supplies IEEE1284-I and -II bi-directional parallel communications and has translation capability that allows outputs on cable side to interface with 5 V signal. The A port pins have 4 mA totem-pole...

Multiprotocol Transceiver supports 8 different protocols.

Capable of data rates up to 20 Mbps, Model SP3508 single-chip transceiver enables data communications between nodes in Wide Area Network applications. Through operating power supply of 3 V, TTL I/O lines are conditioned to LVTTL signal levels. Device incorporates intelligent charge pump, 8 transmitters, 8 receivers, and 1 Ã-µF charge pump capacitors. It operates in DTE or DCE mode and...

Interface Transceiver Chipset supports 3.3 V logic.

Models LTC2847/LTC2845 come in 5 x 7 mm QFN packages and provide multi-protocol serial port for LAN and WAN equipment with remote access ports. Two-chip solution includes configurable transceivers for data and clock signals with on-chip switchable termination resistor networks and transceivers for control signals. Units operate from single 5 V supply and support RS232, RS449, EIA-530, EIA-530-A,...

RS232 Transceiver suits portable applications.

Offered in 28-pin TSSOP and SSOP packages, SP3281EB employs 5 drivers and 3 receivers and offers 250 Kbps minimum data rate. ESD protection on all I/O pins protects device to Ã-

Precision Fabricating with Over 40 Years of Experience

Quality Sheet Metal specializes in delivering precision, value, and customer service. With a client base that spans many diverse industries and a reputation for excellence that goes back over four decades, our clients know that we can provide the optimal combination of value and flexibility regardless of the challenge. See our video to learn what we can do for you. Through investments in state-of-the-art design, manufacturing, and quality control systems, Quality Sheet Metal remains focused on maintaining a high standard of quality, customer service, and competitive pricing. With an emphasis on customer satisfaction, Quality Sheet Metal is dedicated to establishing long-term partnerships, similar to the ones they currently have with their valued clients. If you're looking for a new partner with extensive capabilities in sheet metal fabricating and finishing, look no further.