Solid State Relays

Solid State Relays and Contactors offer ratings up to 600 Vac.
Solid State Relays

Solid State Relays and Contactors offer ratings up to 600 Vac.

Available in 2 frame sizes of 54 or 70 mm wide,Â- RGC2 and RGC3 Series provide solutions for 2- and 3-pole switching of 3-phase loads. RGC2 offers 3 current ratings of 25, 40, and 75 AAC per pole at 40°C, while RGC3 offers 5 current ratings ranging from 20–65 A per pole. With optional monitoring feature, devices can detect status of mains and load, as well as internal RGC failures....

Read More »
AC Solid State Relay features 5 KV isolation voltage.
Solid State Relays

AC Solid State Relay features 5 KV isolation voltage.

Offered in 8-pin Power SOIC package, 60 V Model CPC1907B handles load currents up to ±6 Adc or 6 Arms and features low On-Resistance ofÂ- 0.06 Ω. Single-pole, normally open unit employs optically coupled MOSFET technology to provide 5,000 Vrms input to output isolation. Switching of MOSFET is controlled by photovoltaic die using OptoMOS architecture, while activation of output...

Read More »
AutomationDirect Expands Pneumatic Cylinder Position Switch Offering
Solid State Relays

AutomationDirect Expands Pneumatic Cylinder Position Switch Offering

The NITRA® line of pneumatics products now includes nine styles of position switches for pneumatic cylinders, including round, dovetail, t-slot, square, and D-shaped; additional dovetail accessories are available to accommodate larger dovetail slots. The new styles are solid-state electronic switches available in normally-open 3-wire DC PNP and NPN configurations, and can be purchased with...

Read More »
Solid State Relays

Self-Resetting Isolated SSR implements triple protection scheme.

Incorporating load current-limiting, over-voltage protection, and thermal management, CPC1593 NO (1-Form-A) optically isolated, bidirectional SSR has 600 V peak max load voltage,Â- Ã‚±120 mA max continuous load current, and 35 Ω max on-resistance. When voltage across switch exceeds 21 V and device is in current limit, switch deactivates, while restricted load current of...

Read More »
Solid State Relays

PIN Diode RF Switches operate at frequencies up to 40 GHz.

Solid-state RF switches have frequency range of 500 MHz to 40 GHz and power rating of 0.1 W at 20 dBm. Featuring switching speeds as low as 1 Â-µs, absorptive, active microwave switches route RF signal through set of transmission paths. Products can be used for routing varying RF signals between microwave test instruments, allowing multiple tests at once. They include...

Read More »
AC Power Relay includes zero-cross turn-on circuitry.
Solid State Relays

AC Power Relay includes zero-cross turn-on circuitry.

Utilizing dual power SCRs as integrated alternative to discrete optocoupler and triac circuits, 3 Amp CPC1966B Solid State SwitchÂ- features blocking voltage of 800 V, and 30 A surge rating that enables it to handle variety of resistive and reactive loads. Eight-pin Power SOIC package provides 5,000 Vrms of isolation between input control and output, while optically coupled circuitry...

Read More »
Hermetic Solid State Relay features 15 A rating.
Solid State Relays

Hermetic Solid State Relay features 15 A rating.

Housed in modular package with no moving parts, Series 861H features internal heat sink, internal snubber, finger-safe terminals, LED indicator light, and DIN or panel mounting. Intrinsically safe unit achieves Class 1, Division 2 rating from Underwriters Laboratories® for approved use in Groups A, B, C, and D hazardous locations. Providing SPST normally open operation, relay is suitable...

Read More »
AUTOTESTCON 2012 in Anaheim, California September 10th -13th, at the Disneyland Resort and Conference Center, Pickering Interfaces Booth number: 406
Solid State Relays

AUTOTESTCON 2012 in Anaheim, California September 10th -13th, at the Disneyland Resort and Conference Center, Pickering Interfaces Booth number: 406

Clacton-on-Sea, UK - Pickering Interfaces, a leading PXI/LXI Supplier has continued in 2012 to regularly release a steady flow of new products in both the LXI and PXI platforms. At AUTOTESTCON - this major conference and exhibition provides focus on the maintenance aspects of systems readiness and provides Mission Assurance through Advanced ATE. This includes Maintenance Repair & Overhaul as well...

Read More »
Vaunix to Demo Several New USB Lab Bricks at IMS
Solid State Relays

Vaunix to Demo Several New USB Lab Bricks at IMS

Haverhill, MA - At IMS booth #1129 in Montreal, Canada, Vaunix Technology Corporation, a manufacturer of USB controlled and powered test equipment, will be offering demos of their new LSW Series Switches and new models in their family of LDA Series Digital Attenuators. The switch line is a new Lab Brick product family offering 10 W power handling capability and reliable, high isolation, low power...

Read More »
Solid State Relays

Vishay to Showcase Power Electronics for Solar Energy at Intersolar Europe 2012

Vishay Intertechnology to Showcase Broad Range of Standard and Special Power Electronics for Solar Energy at Intersolar Europe 2012 MALVERN, Pa. - Vishay Intertechnology, Inc. (NYSE: VSH) today announced that the company will be presenting powerful and energy-efficient power electronics products such as rectifiers, resistors, aluminum and film capacitors, diodes, MOSFETs, and optocouplers at...

Read More »
Neagle Choice, LLC Announces New Available Services
Sponsored

Neagle Choice, LLC Announces New Available Services

Neagle Choice has long been known as a quality source for commercial sewing, printing, die cutting, and the manufacturing of a wide range of custom products. Enhancing our service capabilities has been the key to our success, and has driven our growth into many new and exciting markets. Continuing on this trajectory, we now offer precision laser cutting and etching, adding to our long line of manufacturing services. See our video to learn all about it.

Read More »

All Topics