Signal Receivers

Signal Receivers

Set-Top Box SoCs enable multi-room DVR throughout home.

Equipped with Multimedia over Coax Alliance 1.1 core, Model BCM7342 acts as media center to enable service providers to offer multi-room DVR capabilities, while Model BCM7340 acts as thin media client, allowing multiple users to store, time shift, or access content from media servers or residential gateways for playback on STBs anywhere in home. Both satellite receivers feature dynamic power...

Read More »
GPS Timing Receiver targets WiMax applications.
Signal Receivers

GPS Timing Receiver targets WiMax applications.

Designed for synchronization and timing in WiMax applications, surface mount TiMax Wi125 features programmable NCO oscillator that outputs synthesized frequency up to 30 MHz, which is steered by GPS receiver. Self-survey mode allows receiver to enter position hold mode, allowing accurate timing to be continued with only 1 satellite being tracked. Additional features include phase alignment of 1...

Read More »
Signal Receivers

GPS Receivers support asset and inventory tracking.

Integrating Ekahau's location tracking software, FCC Certified NavTrac Wi-Fi-enabled GPS Devices can track location of assets and inventory in any environment. GPS solution delivers low signal strength GPS tracking data for outdoor and other GPS coverage areas, while Ekahau Positioning Engine and its algorithms calculate precise real-time location in indoor environments or campus settings where...

Read More »
GPS Receiver Module utilizes AEC-Q compliant components.
Signal Receivers

GPS Receiver Module utilizes AEC-Q compliant components.

Based on SiRFstarIII chipset, Model A1088-A is completely shielded and designed for use with active antennas, reaching acquisition sensitivity of -145 dBm. In tracking mode, sensitivity goes down to -159 dBm and current draw is typically 32 mA at 3.3 V. Module includes additional low power modes where current draw can be reduced to 10 Â-µA. Measuring 19 x 28 mm², module is specified...

Read More »
Receiver handles ASK/OOK data at 300-450 MHz frequencies.
Signal Receivers

Receiver handles ASK/OOK data at 300-450 MHz frequencies.

Model MAX7036 superheterodyne receiver integrates self-contained PLL block; 400 kHz IF filter with RSSI; and analog baseband, data-recovery circuitry. Operating over -40 to +105°C temperature range from 3.3 or 5 V power supply, it offers sensitivity of 109 dBm and draws less than 1 Â-µA in shutdown mode and 5.5 mA in receive mode. Power-down pin puts unit in low-current sleep mode and...

Read More »
Transmitter/Receiver Pairs enable HDMI over fiber connections.
Signal Receivers

Transmitter/Receiver Pairs enable HDMI over fiber connections.

Allowing HDMI device to be added in analog room, HD-TX1-F and HD-RX1-F units extend uncompressed HDMI and IR/RS-232 control signals up to 1,000 ft over single multimode fiber connection. They can also connect 2 HDMI switchers in different parts of building so source or display device can be located remotely from central equipment. Pairs include universal IR repeaters with range of up to 192 kHz,...

Read More »
DPD µModule® Receiver simplifies basestation design.
Signal Receivers

DPD µModule® Receiver simplifies basestation design.

Supplied in 11.25 x 15 mm LGA package, LTM9003 wideband RF-to-digital receiver subsystem includes 12-bit, 250 Msps ADC, bandpass filter, IF amp, and RF downconverting mixer. IC reduces board space and development time for wireless basestations implementing PA linearization with digital predistortion (DPD). Included 125 MHz bandpass filter exhibits less than 0.5 dB passband ripple, and noise floor...

Read More »
Fire-Lite Identifies IP Monitoring Trend
Signal Receivers

Fire-Lite Identifies IP Monitoring Trend

Central Stations View Internet as Future Fire Systems Monitoring Standard NORTHFORD, Conn., July 1, 2009 - Fire-Lite Alarms by Honeywell has witnessed an increase in central station companies monitoring fire alarm systems via the Internet, equating this trend to growing sales of its FireWatch IP Communicators and compatible VisorALARM-Plus receivers. FireWatch IP Communicators offer dealers a...

Read More »
ComNet Introduces Second Generation Video and Data Fiber Optic Product Line
Signal Receivers

ComNet Introduces Second Generation Video and Data Fiber Optic Product Line

All New Video with Up-The-Coax Data Product to Debut Danbury, CT. June 30, 2009, Communication Networks of Danbury, Connecticut, doing business as ComNet(TM), a manufacturer of fiber optic transmission and networking equipment, has introduced and officially released their second generation of digital fiber optic video and data transmitters and receivers. The FVT1031UTC and FVR1031UTC Series are...

Read More »
Signal Receivers

Transmitter/Receiver uses ISM band to relay level data.

Enabling transmitting of data between process sensors/DCS or SCADA systems, DX80 Wireless Transmitter and Receiver includes wireless transmitter node accepting up to 2 analog and 2 discrete switch inputs. Including wireless receiver gateway that accepts up to 55 nodes, system has embedded site survey tool which analyzes strength of radio signal between gateway and specified node. Housed in IEC...

Read More »

All Topics