Shifters

Custom MMIC Introduces New Low Noise Amplifier and Phase Shifter with 50 Ohm Matched Design
Electronic Amplifiers

Custom MMIC Introduces New Low Noise Amplifier and Phase Shifter with 50 Ohm Matched Design

Custom MMIC adds CMD270P3 and CMD174 to its LNA and phase shifter portfolio. The CMD270P3, 4-8 GHz amplifier is offered in 3 x 3 mm plastic surface mount package. The amplifier delivers a gain of greater than 16 dB with corresponding output of 1 dB compression point of +18 dBm and a noise figure of 1.7 dB. The CMD174 phase shifter is operated in 3 to 6 GHz and offers 0 to 360 degrees of monotonic...

Read More »
New Quadrant Shifting System Increases Simulation Treatment Rate
Shifters

New Quadrant Shifting System Increases Simulation Treatment Rate

The Quadrant™ Shifting System consists of shifting tool and closeable sliding sleeves that maximizes reservoir contact. The system is designed for activating sliding sleeves without a packer element. The unit’s design minimizes wellbore drag and reduces operational risk in long laterals. Quadrant system features a horizontal well with measured depth of more than 2,750 m.

Read More »
Analog Voltage Variable Phase Shifter
Shifters

Analog Voltage Variable Phase Shifter

This family of drop-in size phase shifters offers a 225 degree (min.) phase shift at 20 volts (max.) control voltage in various bands from 6 to 16 Ghz. They are available with field removable SMA connectors so that they can be use either as stand-along phase shifters, or installed into printed circuit boards as part of a test & measurement radar system. These phase shifters are particularly well...

Read More »
Waveguide Phase Shifters provide phase shift of 0 to 180 degrees.
Shifters

Waveguide Phase Shifters provide phase shift of 0 to 180 degrees.

Having a frequency range from 18 GHz to 110 GHz in 7 waveguide bands from K to W band, Waveguide Phase Shifters are constructed of gold-plated brass waveguide material. Delivering maximum insertion loss of 1dB, units are suitable for aerospace, defense, industrial, telecom, instrumentation applications. Phase shifters are available in sizes ranging from WR-42 to WR-10.

Read More »
Programmable Phase Shifters feature integrated hybrid MIC design.
Shifters

Programmable Phase Shifters feature integrated hybrid MIC design.

Available in three models for producing phase states of up to 256 total steps in 1.4° increments, Programmable Phase Shifters are suitable in aerospace, defense radar and EW applications. Designed with 8-bit TTL digital-to-analog converter, units cover 0.5 to 18 GHz frequency band. Featuring 30 to 265 nsec switching speed with +13 dBm to +30 dBm maximum input power range, phase shifters are...

Read More »
Analog Phase Shifters housed in rugged Kovar packages.
Shifters

Analog Phase Shifters housed in rugged Kovar packages.

Suitable for radar systems and test equipment, Analog Phase Shifters operate on analog control voltage ranging from 0V to +5V. PE82P2000 and PE82P2001 Phase Shifters support a modulation bandwidth of 50 MHz. PE82P2000 covers 5 GHz to 18 GHz providing monotonic phase shift range of 0° to 400° typical and 7dB insertion loss. PE82P2001 covers 6 GHz to 15 GHz with monotonic phase shift range of...

Read More »
Analog Phase Shifters support frequency bands from 5-18 GHz.
Shifters

Analog Phase Shifters support frequency bands from 5-18 GHz.

Used to control phase characteristics in processing of microwave signals, PE82P2000 and PE82P2001 can also be used as phase modulators to control modulating baseband signal. MIL-Spec compliant units come in rugged, hermetically sealed Kovar packages with gold-over-nickel plating. Respectively, PE82P2000 and PE82P2001 cover 5–18 GHz and 6–15 GHz with continuously variable and...

Read More »
Miscellaneous Controls

X-Band MPAC-Beamforming Device covers 8-12 GHz range.

Designed for X-band radar applications, UltraCMOS® PE19601 integratesÂ- 6-bit digital step attenuator, 10-bit digital phase shifter, RX/TX switching, and digital serial interface on 2.6 x 4.65 mm bare wirebond monolithic die. Monolithic phase and amplitude controller (MPAC) solution, consuming 0.001 mA, offers >40 dBm IIP3 linearity, 50 dB isolation, 17...

Read More »
Electronic Filters

Analog Modules target engineers and instructors.

RLC Divider Board was developed to implement passive filters and various R, L, and C networks, whileÂ- Level Shifter Board is designed to interface I2C or SMBus signals between devices with different VDD voltages. Using OPA172 operational amplifier, OpAmp Board includes specific features that make it suitable for experimentation. Active Filter Board is suited for use as anti-aliasing filter...

Read More »
RF Digital Phase Shifter targets active antenna applications.
Circuits

RF Digital Phase Shifter targets active antenna applications.

Operating in 1.7–2.2 GHz frequency range, 8-bit UltraCMOS® PE44820 is suited for optimizing transmission phase angle in wireless infrastructure and radar markets. Monolithic deviceÂ- covers phase range of 358.6° in 1.4° steps with phase accuracy of +3°. Offered in 32-lead 5 x 5 x 0.85 mm QFN package, product has low RMS phase error of 1° and low RMS amplitude...

Read More »
Fresh Air Intake Designed to Meet ASHRAE 62.2 standards
Sponsored

Fresh Air Intake Designed to Meet ASHRAE 62.2 standards

Alan Manufacturing has a long history of developing innovative solutions for HVAC applications. With over 1,000 product designs under our belt, we have gained a reputation as the go-to source for HVAC dampers, hardware, duct supports, zone control systems, and much more. Adding to this extensive list of achievements we now announce the release of our new line of Fresh Air Intake products. Designed to meet ASHRAE 62.2 standards, they are the most robust and high-performance product of their kind. See our video to learn more.

Read More »

All Topics