New Sensors, Monitors & Transducers Products

Oxygen Monitor checks control rooms.

Wall-mounted GPR-35 provides two adjustable alarms that are factory set at OSHA standard 20.0% CAUTION and 19.5% DANGER oxygen levels. Optional high and low level oxygen alarms are also available. Oxygen concentration measurements are displayed on 3-1/2 digit LCD. Two color LED alarm indicators illuminate deficiency levels: green for safe, red for alarm. Automatic compensation for barometric...

Pressure Transmitter resists corrosion.

Made of titanium or stainless steel, Model 517 submersible pressure transmitter provides pressure readings in ranges from 30 in. to 1,200 ft of water. It is less than 7/8 in. dia., has HDPE or neoprene cable, piezoresistive sensor, accuracy of 0.05% FS, and lightning protection. Versions with FM/CSA intrinsic safety approvals are available. Its 4 to 20 mA signal minimizes potential outside...

Color Sensor works without external light source.

BFS-26K measures red/green/blue component of reflected light and shades of gray in single processing step. It uses integrated, pulsed white light source that eliminates need for external illumination and makes it insensitive to ambient light. Each of its three digital outputs can be calibrated using five color resolution tolerance levels. It can be programmed through control line or using...

Signal Conditioner handles smart sensors.

Three-channel Model 433 amplifier card works with single-ended piezoelectric and ISOTRON(R) accelerometers, remote charge converters, and i-TEDS IEEE P1451.4 smart sensors. Microprocessor provides fast data transfer with reliability. Gain is programmable from 0 to 1000 while accuracy is 0.5% at 1 kHz for gains greater than 1.0. Card plugs into company's Model 4990 and 4998 racks, and can be...

Whitepaper: 7 Trends for IoT in Hospitality

Check out this white paper to see how the IoT can be used in your hotel to reduce energy consumption, increase guest satisfaction, improve maintenance, and more.

Portable Air Monitor includes downloading software.

Microprocessor-based HAZ-DUST EPAM-5000, for environmental and indoor particulate monitoring, combines light-scattering dust monitoring with inline 37 mm filter cassette for concurrent gravimetric samples. It samples particles from 0.1 to 100 micrometers, using adjustable flow rate from 1.0 to 5.0 L/min, and reads particles from 0.001 to 20.0 mg/m3. Interchangeable size-selective sampling heads...

Heat Stress Monitor can be hand-held or fixed-mounted.

Model hs-32 WBGT area heat stress monitor measures humidity, temperature, and radiant heat conditions that can cause heat stroke and likewise heat-induced illnesses. With on-board humidity sensor, hs-32 displays relative humidity and calculates Heat Index or Humidex. Other features include covered wet bulb reservoir, shielded dry bulb, removable sensors, and 2 or 6 in. globe. Set-up options...

Sensors offer simultaneous position and velocity sensing.

Temposonics(R) R Series Profibus DP sensors feature position resolutions down to 0.0002 in. and velocity resolutions down to 0.04 in/sec. They offer stroke ranges up to 33 ft. Interface enables diagnostic capabilities and error-free transmissions over high-speed serial data link. Sensors operate up to 32 units per line segment and can sense up to 15 magnet positions simultaneously. Rod, profile,...

Level Probe withstands high pressure steam.

Model 7XS high temperature/high pressure steam probe for Eclipse guided wave radar transmitters operates at 605 deg F @ 1,585 psi and withstands corrosive nature of steam applications. It measures levels in saturated steam applications, such as boilers, de-aerators, and feed water heaters.

Sensors have ASCII communications protocol.

ServoSensor S Series provides closed-loop position performance with better than 1 msec loop times and resolutions less than 0.001 in. Sensors store closed-loop gains and operational parameters, and offer interface to Allen Bradley ControlLogix or Automation Direct 205 PLC platforms using RS View or Visual Basic programming. They allow for multiple axis control of up to 26 axes per communication...

Pressure Sensors feature EMI resistance.

Pressure Sensors, with pressure ratings up to 10,000 psi, can handle steam and refrigeration applications. One-piece pressure cavity is machined from 17.4 PH stainless steel, which offers no source for contamination of process fluid or sensor. Sensors measure process fluids in demanding, pulsating, and vibrating environments.

Standex Engraving Mold-Tech Offers Nickel Shell Capabilities on a Global Scale

Standex Engraving Mold-Tech is the premier, global supplier for mold texturing and surface finishing. With a full range of services, Standex Engraving Mold-Tech is also the only nickel shell supplier producing in three global locations. See our video to learn more.