Control Box accurately pressurizes air casters.
Pressure Regulators

Control Box accurately pressurizes air casters.

Control Box provides precise pressure regulation to each air caster while floating large loads on thin film of air. It includes 4 or 6 self relieving pressure regulators with gauges, on/off inlet ball valve, main air supply pressure gauge, transport handle, and quick disconnect outlets. Box allows main plant air supply to be distributed to each individual air caster, compensating for off-centered...

Read More »
Step-Down Regulator delivers 4 A in less than 3 cm².
Electrical Regulators

Step-Down Regulator delivers 4 A in less than 3 cm².

Model LTC3414, 4MHz synchronous buck regulator uses constant frequency, current mode architecture. Unit is able to deliver up to 4 A continuous output current at voltages as low as 0.8 V from thermally enhanced TSSOP-20 package. It operates from input voltage of 2.25-5.5 V and integrates internal MOSFET switches with RDS(ON) of 0.067 ohms to deliver efficiencies as high as 95%. Unit has no load...

Read More »
Electrical Regulators

Low-Dropout Regulators power DSPs, FPGAs, and ASICs.

Series LP385x CMOS LDO regulators feature output currents of 1.5 and 3.0 A, logic-controlled on/off, error flag or separate sense pin, over-temperature, and over-current protection. Typical dropout voltage is 240 mV at 1.5 A and 390 mV at 3.0 A load, allowing designers to generate high-eeficiency 2.5 V output from 3.3 V supply up to 2.5 A. Output-voltage accuracy is ±1.5% at room...

Read More »
Switching Regulator delivers 3 A peak current.
Electrical Regulators

Switching Regulator delivers 3 A peak current.

Model LT3431 high voltage, constant frequency, step-down switching regulator utilizes 3 A internal switch. It operates with inputs from 5.5-60 V and can deliver up to 2.75 A of continuous output current at voltages as low as 1.25 V. Regulator utilizes constant 500 kHz switching frequency, keeping external components small. Sync pin allows for external synchronization from 580-700 kHz with logic...

Read More »
Switching Regulators offer thermally enhanced packages.
Electrical Regulators

Switching Regulators offer thermally enhanced packages.

Models LT1766EFE and LT1956EFE constant frequency, step-down DC/DC switching regulators include 1.5 A internal switch. Both operate within VIN range of 5.5-60 V and can deliver up to 1.25 A of continuous output current at voltages as low as 1.25 V. Model LT1766EFE utilizes 200 kHz switching frequency, while Model LT1956EFE switches at 500 kHz. Exposed pad package integrates copper pad at bottom...

Read More »
Electrical Regulators

Linear Regulators offer low dropout.

Models LP3883/2/1 CMOS dual-input, voltage regulators enable high efficiency linear conversion from 1.8-1.5 V and 1.2 V for notebook and set-top box applications, while consuming low quiescent current of only 3 mA. Power input may be fed independently from high current supply facilitating conversion from input rails of less than 2.5 V. Dropout voltage for Models LP3883/2/1 is typically 210 mV/110...

Read More »
Margining Controller simplifies automated PCB testing.
Electrical Regulators

Margining Controller simplifies automated PCB testing.

Model LTC2920 power supply margining controller allows supply rails to be precisely adjusted up and down during PCB testing. It sources or sinks current into feedback node of controller chip or voltage adjust pin of regulator module. Margining current is set with single resistor channel. Output current is settable over 400:1 range and margin voltage precision of

Read More »
Pressure Regulating Unloader features all 316 SS construction.
Pressure Regulators

Pressure Regulating Unloader features all 316 SS construction.

Model 7501 offers flow-thru design that mounts easily into pump discharge line. Pressure sensitive feature permits flows from .5-6 gpm, and consistent spring rate allows pressure adjustment from 100-2000 psi. Unit sets precise system pressure and immediately goes into by-pass when trigger gun is released or downstream line becomes plugged. Removable check valve offers both primary and secondary...

Read More »
Pressure Regulators suit applications in excess of 60 scfm.
Pressure Regulators

Pressure Regulators suit applications in excess of 60 scfm.

Series 228 single-stage regulators are available in 316 SS for use with corrosive gases or brass bar stock for use with non-corrosive gases. Balanced poppet stem design minimizes effect on delivery pressure caused by changes in inlet pressure. Regulators feature 316 SS diaphragm, PCTFE seat, Teflon® seals, and nickel-plated brass bonnet. Max inlet pressure is 3,000 psig. Operating...

Read More »

All Topics