Power Correction System uses active harmonic filtering.

Power Correction System uses active harmonic filtering.

MCC-mounted ACCUSINE(R) Power Correction System (PCS), with expandable, scalable filter, quickly reacts to harmonic waveforms to produce harmonic cancellation waveforms. System decreases harmonic-related overheating of cables, switchgears, and transformers. Response to load fluctuations begins in 40 microseconds, with 8 milliseconds for full response to step load changes. Device filters to 50th...

Read More »
Pump Protector prevents pump from running dry.

Pump Protector prevents pump from running dry.

Stator protection device consists of thermocouple mounted in stator, temperature sensor, and temperature controller. Thermocouple continuously measures stator temperature over ranges from 0 to 255 deg C. If stator temperature rises above specified cut-off point, optical or acoustic signal shows on controller display. Controller can also be set to switch pump off immediately. Applications include...

Read More »
Horizontal Lifeline works on I-beams or concrete.

Horizontal Lifeline works on I-beams or concrete.

Miller(R) DeltaForce(TM) horizontal lifeline lets workers maintain 100% tie-off for continuous fall protection along entire lifeline. It attaches to rebar or single flared coil inserts and is available in single-span systems up to 60 ft and multiple-span systems up to 300 ft. System includes 2 end stanchions, 3/8 in. steel galvanized wire rope lifeline, inline shock absorber, turnbuckle,...

Read More »
Lifeline arrests falls within two feet.

Lifeline arrests falls within two feet.

Miller(R) MightyLite sealed self-retracting lifeline provides fall protection for workers involved in ladder and tower climbing, yet provides freedom of movement. It is available in 20, 30, 50, 65, 100, 130 and 175 ft lengths, with stainless steel, galvanized wire rope, or polyester webbing. Lifelines meet OSHA, ANSI and CSA standards and do not require annual factory recertification. Sealed...

Read More »
Battery Protection IC provides over-current detection.

Battery Protection IC provides over-current detection.

S-8243A/B Series incorporates battery protection circuits, battery monitor amp, and voltage regulator, reducing board space requirements. 3-serial and 4-serial cell LI-ION ICs have 3 levels of detection: over-charge (+/- 25 mV), over-discharge (+/- 80 mV) and over-current (+/- 25 mV). Applications include notebook computers, hand-held scanners, and other portable electronic devices that use...

Read More »
Platform offers fall protection.

Platform offers fall protection.

INSTA-RACK features single pedestal platform with access stairway and equipment. Unit provides safe access and fall protection to tops of bulk/tank trucks, tank cars and hopper cars.

Read More »
Circuit Monitor detects oscillatory and impulsive transients.

Circuit Monitor detects oscillatory and impulsive transients.

POWERLOGICÂ-® Series 4000 permanently mounted circuit monitor with transient detection (CM4000T) automatically generates alarm so that action may be taken to correct problems before facility shuts down. It detects and captures oscillatory and impulsive transients (up to 10,000V peak, line-to-line) as short as 1 microsecond in duration. CM4000T maintains historical record of number of...

Read More »
Network Protector has 4-position circuit breaker.

Network Protector has 4-position circuit breaker.

CM52 is UL-qualified, and handles ratings from 800 to 6200 A, 216 to 600 V. It offers electrically operated, composite case, spring-closed, draw-out, dead-front air network circuit breaker controlled by MPCV network relay. CM52 meets or exceeds standards in IEEE C57.1244. Color-coded wiring and front accessible test switch allow for troubleshooting, and diagnostics are built into its Voltage...

Read More »
Lightning Protector handles up to 20,000 W.

Lightning Protector handles up to 20,000 W.

Category 5 High Current protector offers full 20,000 watts of protection and field-tested (with 8/20 micro waveform) real-time CAT 5 functionality. During tests, units were tested repeatedly at 6kV/3kA without failure. Peak voltage seen at output was 33.2 Volts. Protectors are also available for both analog and digital phone circuits, which make them suitable for Voice over IP.

Read More »

All Topics