Preamplifiers

Preamplifiers

NIR Photodiode-Preamp Combo suits medical applications.

Packaged in hermetically sealed TO-39 can, Near-Infrared (NIR) Red-Enhanced 5 mmÂ-² ODA-5W-100K Photodiode-Preamplifier combination device offers 500 MW gain. High-sensitivity, NIR wavelength response at 940 nm is 63 V/mW (typ) and 55 V/mW (min). With operating and storage temperature ranges of -25 to +100°C, product suits applications such as medical diagnostics, test and measurement,...

Read More »
Microphone is suited for NVH studies and biomedical research.
Preamplifiers

Microphone is suited for NVH studies and biomedical research.

Designed for 2D pressure mapping, holography, trending, and frequency analysis, Model 130D22 is combined ICP® free field response pre-polarized array microphone and preamplifier that measures sound pressure levels and frequencies in audible range. It features SMB connector that offers seamless transition for data acquisition systems and software set-ups. Unit can be used simultaneously with...

Read More »
Preamplifiers

STMicroelectronics Completes Full Portfolio of IP for Mobile Hard-Disk-Drive Manufacturers

Offers full kit of System-on-Chip, pre-amplifier, and motor controller IP for small form-factor hard-disk drives used in laptops and portable consumer applications Geneva, October 3, 2006 - STMicroelectronics (NYSE: STM), a world leader in hard disk drive (HDD) and system-on-chip solutions, today announced completion of its portfolio of IP (Intellectual Property) required to design, manufacture,...

Read More »
Preamplifier includes gain, filtering, and TEDS.
Preamplifiers

Preamplifier includes gain, filtering, and TEDS.

Operating from ICP® Sensor Power, Â-½ in. Model 426A11 provides automotive and aerospace noise source identification and in-cabin testing. It allows user to select 0 or +20 dB of gain and either 20 Hz high pass filter or A-weighted filter output response. A-weight filter attenuates signals less responsive to human ear, normally below 1 kHz and above 4 kHz, while high pass filter...

Read More »
Preamplifiers

HDD Preamplifiers lower power demand in portable devices.

Designed for drives with less than 2.5 in. diameter platters, Near Zero Power (NZP) series model L6440 has total Write-Mode power consumption of 170 mW at 450 Mbps data rate and supports max data rate of 600 Mbps. Hard disk drive (HDD) preamplifiers reduce overall power requirements by remaining in sleep mode even most of the time end-product is operating. Fast Sleep Mode combines 250 Â-µW...

Read More »
Preamplifiers

Disk Drive Preamplifiers target portable products.

Intended specifically for drives with less than 2.5 in. diameter platters, Near Zero Power Model L6440 consumes 170 mW and supports max data rate up to 600 Mbps. Combining 250 Â-µW sleep power with 500 ns Sleep-to-Read recovery time, Fast Sleep Mode allows preamplifier to remain in sleep mode most time end product is operating. Four-channel Model L6440 and 2-channel L6420 accommodate both...

Read More »
Krell Announces 2006 Q1 Shipping of Select Evolution Components
Preamplifiers

Krell Announces 2006 Q1 Shipping of Select Evolution Components

The new Evolution lineup of products builds on the design and manufacturing excellence realized with the Evolution One and Two. Orange, CT - February 27, 2006 - Krell Industries proudly announces shipping of the Evolution 202 preamplifier, Evolution 505 SACD/CD player, and the Evolution 402 and 600 amplifiers from their recently introduced Evolution series. The Evolution-branded products round...

Read More »
Preamplifiers

Preamp provides CMM retrofit solution.

Designed for use with Brown and Sharpe reader heads, Deva 023-1SIN-BS1 reader-head preamp performs necessary signal conditioning required for use with Deva 018 Sine Wave Interpolator. It has 15-way D-type connector at one end, which is pin-compatible with existing reader head. Other end of module has high-density, 15-way D-type connector that mates directly with 018 interpolator without custom...

Read More »
Microphone Preamplifier supports TEDS.
Preamplifiers

Microphone Preamplifier supports TEDS.

Featuring 7-pin LEMO connector, Â-½ in. Model PRM905 can be used with both prepolarized and externally polarized microphones. It is characterized by wide frequency range and low noise floor. Low output impedance and high output current permit it to drive very long microphone extension cables. Unit is suited for acoustic engineers using analyzers which support Smart Transducer Interface IEEE...

Read More »

All Topics