Converter provides low voltage inputs for ASICs and DSPs.
DC to DC Power Supplies (Converters)

Converter provides low voltage inputs for ASICs and DSPs.

Model WPA60 DC-DC converter meets EN60950, UL60950, and CSA safety requirements. Two independently regulated outputs deliver 1.8 and 3.3 V, respectively, and provide full regulation down to zero load. Power can be traded between outputs up to 60 W. Input voltage range is 36 to 75 V and includes input and output filtering. Using fixed switching frequency of 350 kHz, WPA60 operates at 90%...

Read More »
DC/DC Converters feature high-voltage isolation.
DC to DC Power Supplies (Converters)

DC/DC Converters feature high-voltage isolation.

With efficiencies up to 82%, V3 Series 2 W converters are supplied in subminiature SIP and DIP packages with isolation voltages or 1,000 or 3,000 Vdc. Input voltages include 5, 12, 24, and 48 Vdc, while single-output voltages range from 3.3-24 Vdc. All isolated outputs are regulated, and no heat sinks are required. Operating temperature range is -40 to +85 °C. SIP package size is 0.76 x...

Read More »
Point-of-Load Converter provides all-in-one power solution.
DC to DC Power Supplies (Converters)

Point-of-Load Converter provides all-in-one power solution.

Dual-output, non-isolated, point-of-load (POL) converter for DDR (double data rate) memory, DDR12, enables 2.5 V VDDQ supply for DDR logic and 1.25 V DDR termination voltage (VTT) to be derived from single module. Unit employs synchronous rectification techniques and has 85% conversion efficiency when operated at half-load or greater. The 2.5 V VDDQ output delivers up to 25 A, and 1.25 V VTT...

Read More »
Power Supplies

Hot-Swappable Power Supply features low, 1U profile.

Series HSF-1U allows for mounting up to four 50 or 100 W modules in 1.75 in. rack adapter, RA-19-1U. It is configured from rear allowing user to create double-redundant system by configuring slots 1 and 3 to operate off one ac branch circuit and slots 2 and 4 from second circuit. Single-output modules from 5 to 48 V feature front panel with switch, test points, voltage trimpot, and dc-on and...

Read More »
Network Management Card includes on-board modem.
Miscellaneous Management Systems

Network Management Card includes on-board modem.

Capable of environmental monitoring, network card sends alerts when changes to ambient temperature and humidity reach levels outside user-set parameters. On-board modem provides remote management of UPS systems, allowing users to monitor network failures and receive event notification at remote sites. It also offers ability to dial in to network card and gain access to UPS. IT managers can also...

Read More »
Power Pack provides 24 Vdc to power occupancy sensors.
Power Supplies

Power Pack provides 24 Vdc to power occupancy sensors.

Model BZ Dual Voltage Power Pack offers true 150 mA output and operates at 120 or 277 Vac, eliminating potential for ordering errors. Hold-OFF feature can be used to perform load shedding. During peak demand or power alert, signal from BMS or utility meter triggers BZ to hold-OFF or shed non-critical lighting loads. Hold-ON input is suitable for retail and commercial facilities that want to hold...

Read More »
DC-AC Inverters power large LCDs.
DC to AC Power Supplies (Inverters)

DC-AC Inverters power large LCDs.

Dimmable Series 8mAD 2-tube inverters power LCDs in 10.4 and 12.1 in. diagonal size range that are backlight by one pair of CCFLS (cold cathode fluorescent lamps) in conjunction at either end of LCD panel using one output connector. Inverters offer on-board connectors and can be dimmed to less than 5% duty cycle using external analog control signal or external PWM generator. Products measure less...

Read More »
Inverters offer selectable switching frequency to 15 kHz.
DC to AC Power Supplies (Inverters)

Inverters offer selectable switching frequency to 15 kHz.

CFW-08 Plus micro inverters include 10 hp (3 phase 460 Vac), 5 hp (3 phase 230 Vac,) and 3 hp (single phase 230 Vac) and allow variable frequency drive to be applied in a variety of industrial uses. Features include sensorless vector operation, dynamic braking, optional remote keypad with copy function to simplify multi-drive set-ups, and serial communications including Modbus-RTU in addition to...

Read More »
DC-DC Converters feature miniature DIP package.
DC to DC Power Supplies (Converters)

DC-DC Converters feature miniature DIP package.

Fully encapsulated Series SB05 provides output power of 5 W. Converters accept single-range and 2:1 wide range inputs from 9-75 Vdc, and provide single and dual outputs from 3.3-24 Vdc. All contain short circuit protection, internal input filter, and 1600 V input-to-output isolation. They operate over temperature range of -25 to +71°C without forced cooling or output power derating.

Read More »
Switching Power Supply provides 700 W.
Power Supplies

Switching Power Supply provides 700 W.

Model PFC700-S modular, power factor-corrected switch-mode power supply provides single isolated output of 600-700 W continuous power. It corrects input current waveform to better than 0.99 power factor at supply's full load of 120 Vac. Open frame unit featurs current sharing as standard with hot swap capability as option. Output voltages range from 2-48 V. Unit is HALT tested and compliant with...

Read More »
Oilfield Improvements® Wheeled Rod Guide® Couplings Celebrate 35th Anniversary
Sponsored

Oilfield Improvements® Wheeled Rod Guide® Couplings Celebrate 35th Anniversary

For over 35 years our Wheeled Rod Guide Couplings, have been at work in oil fields across the globe. Our products are engineered to extend the service life of sucker rods and tubing, delivering cutting-edge innovation that enhances oilfield operation, maximizes output, and enhancing overall operations. To learn about the advantages of using Wheeled Rod Guide Couplings in your wells, see our video.

Read More »

All Topics