Electric Clutches Reduce Energy and Increase Pump Life
Clutches

Electric Clutches Reduce Energy and Increase Pump Life

Ogura's electromagnetic clutches are designed to provide a quick engagement and disengagement of hydraulic and other pumps used on gas and diesel engines. Clutches are mounted between the engine and the pump and are made for either a belt input or direct drive via a universal joint flange. Clutches are available in 200, 400, 1,000 and 1,500 lb-ft. All clutches use a bidirectional armature so they...

Read More »
Gearheads and Gearboxes

Planetary Gearbox features sturdy, reliable construction.

Available in round and square versions with respective standard diameters of 1.200 and 1.496 in., G30A can achieve reduction ratios to 46,656:1 in 4:1, 5:1, and 6:1 multiples. Max load capabilities range from 106 oz-in. for single-stage models up to 1,250 oz-in. for versions with 4-stages or greater. Intended for Pittman® DC motors, gearbox comes in 0.895-1.585 in. lengths and weighs...

Read More »
Plain Bearings (Bushings)

Hydrodynamic Fluid Film Bearings suit high-load/high-speed applications.

Hydrodynamic bearings are designed for use in large electrical generators and motors, turbines, compressors, and pumps. Thin layer of pressurized lubricant is used between bearing surfaces, so there is no metal-to-metal contact and no maintenance required. Bearing assemblies are offered in pedestal, mid-flange, and end-flange configurations and bearing shaft sizes from 55-1,400 mm and frame sizes...

Read More »
Plain Bearings (Bushings)

PTFE-Based Metal-Polymer Bearing Material offers low friction.

Suited for industrial applications, DP(TM)11 provides optimal dry wear performance under high-frequency/low-amplitude oscillating movements. Structure includes steel backing, porous bronze interlayer, and sliding layer of PTFE with solid lubricant and fillers which allow for maximum static loads of 250 MPa and dynamic loads up to 140 MPa. Operating in temperatures from -200 to +280°C,...

Read More »
Bearings

Self-Lubricating Composite Thrust Bearings are maintenance free.

MegaLife® XT bearings feature self-lubricating sliding layer that consists of seamless tape liner of PTFE blended with high-strength filler and bonded to both sides of composite, fiberglass core. They resist permanent deformation from impact loading and typically recover original shape. Non-conductive to preclude galvanic reactions, units also offer maximum sliding speed of 0.50 m/sec and...

Read More »
Bearings

Precision Bearing Technologies Featured at Atlantic Design & Manufacturing Show

Advances in Ball Bearing Materials, Lubrication Techniques, and Design Assistance Highlighted by AST Bearings at Javits Convention Center June 8-10, 2010: Booth 133 - Jacob Javits Convention Center, New York, NY - One of the most important design and manufacturing shows in the entire United States is scheduled for the first week in June in New York City. This is a must see exposition for...

Read More »
Shafts

Ringfeder Offers GERWAH® Full Product Line to Meet a Variety of Power Transmission Applications

Westwood, NJ - Ringfeder Power Transmission USA Corporation now offers the full line of GERWAH® products, which consists of magnetic couplings, metal bellows couplings, servo-insert couplings, line shafts, RING-flex® couplings and safety couplings to meet a variety of power transmission applications. GERWAH® couplings are used wherever servo motors are used and need a coupling...

Read More »
Turbines

Siemens Secures Order for Its Single Largest Onshore Wind Project in the United States

Erlangen, Germany, May 19, 2010 - Siemens Energy recently secured an order for its single largest U.S. wind turbine project. Puget Sound Energy, Washington state's oldest, local energy utility, has ordered 149 wind turbines rated at 2.3 megawatts (MW) each for the Lower Snake River Wind Project in Washington state's Garfield County. With an installed capacity of 343 MW, the wind power facility is...

Read More »
Irsching 5 Combined Cycle Power Plant Near Ingolstadt Sets New Standards
Controls and Controllers

Irsching 5 Combined Cycle Power Plant Near Ingolstadt Sets New Standards

Siemens built the plant as a turn-key project On May 17, 2010, after around two years of construction, the Irsching 5 combined cycle power plant near Ingolstadt was put into operation in an official ceremony. The owner of the new plant is GKI (Gemeinschaftskraftwerke Irsching GmbH), a project company consisting of E.ON Kraftwerke GmbH, N-ERGIE AG, Mainova AG and HEAG Südhessische Energie AG....

Read More »
Controls and Controllers

Siemens to Supply Power Island Equipment to California

Siemens Energy has received an order to supply the power island for the repowering of El Centro Generating Station Unit 3 in California. ARB, Inc., a multinational construction company, will be the EPC contractor for the facility. Operator and owner of the power plant is Imperial Irrigation District (IID), California's third largest public power provider. Construction will begin on the project in...

Read More »

All Topics

COVID-19 Response Suppliers COVID-19 Response:
Can Your Company Help Provide Critical Supplies?

We are using the power of our platform to aid in the mass shortage of critical supplies. If your company can help provide supplies, capabilities, or materials for products such as N-95 Masks and Tyvek SuitsPlease let us know.

COVID-19 Response Suppliers