Turbines

Siemens to Supply Power Plant Components to Saudi Arabia

Siemens Energy has secured an order to supply gas turbine packages to Saudi Arabia. The components are to be installed in the Hail Extension II and Al Qurayat Expansion II power plants. Purchaser is the Alfanar Construction Company and Saudi Services for Electromechanic Works (SSEM) respectively. These two companies will perform the project on turnkey basis for the Saudi Electric Company (SEC)...

Read More »
Actuators

Beaver Aerospace & Defense Introduces Life Extension Kit for Patriot Missile Outrigger Actuators

Livonia, Michigan - Beaver Aerospace & Defense, Inc., a global leader in the design and manufacturing of unique and broad-range actuation technologies, has designed a life extension kit for J16116 Outrigger Actuators used on the Patriot Missile launch and radar trailers. The kit consists of a stainless steel ball screw, improved seals and bearings to provide longer life by eliminating corrosion...

Read More »
Rotary Actuator is suited for rotating heavy loads.
Actuators

Rotary Actuator is suited for rotating heavy loads.

Available in 6 different sizes, SRU-plus rotary actuator offers choice of 2 dampening versions; soft dampening version for short cycle times, and hard dampening version with heavier payload capability. Options include electric and fluid feed through, continuous adjustment of end positions, as well as pneumatic or locked middle position versions.

Read More »
Motor Controllers and Drives

NEMA 4X/IP66 AC Drive withstands harsh environments.

Series V1000-4X features epoxy-coated, corrosion-resistant enclosure that meets NEMA type 4X/12 indoor use requirements, UL type 4X/12 standards, and IP66 rating of IEC 60529. Drives come in 200-240 Vac, 50/60 Hz single-phase versions rated from 1/8-5 hp as well as 200-240 Vac and 380-480 Vac 3-phase, 50/60 Hz versions rated from 1/8-25 hp. Function-block diagram programming, DIO, and 2 msec scan...

Read More »
Torque Connectors eliminate cordset over-tightening.
Clutches

Torque Connectors eliminate cordset over-tightening.

Compatible with all existing M12 products, M12 true torque connectors can be hand-tightened to predefined torque to avoid over-tightening. Users are alerted to achievement of proper torque when nut rotates freely, indicated by clear haptic and audible signal. This helps maintain integrity of mechanics and o-ring connection. Featuring 3, 4 or 5 poles, both male and female versions are available in...

Read More »
Turbines

Siemens to Supply 68 Wind Turbines for Griffin Onshore Wind Power Plant in Scotland

Siemens Energy has received an order for the supply of 68 wind turbines with a capacity of 2.3 megawatts (MW) each. Purchaser is SSE Renewables (SSER). The Griffin wind power project is located approximately 30 kilometers northwest of Perth in the Scottish Highlands. The wind power plant will have a capacity of 156 MW upon its completion in 2012, and is expected to generate enough power to supply...

Read More »
Submersible 48 VAC Pump Motor
Motors

Submersible 48 VAC Pump Motor

Bodine Electric's engineering team recently developed this new 48 volt AC submersible pump motor for an outdoor application. The motor is completely under water when it is operated. To address the customer's design challenges, Bodine Electric had to develop a unique 48VAC motor winding, and meet all mechanical and environmental requirements for a submersible motor design (IP-58). Bodine...

Read More »
IP54-Rated DC Gearmotor develops 214 lb-in. torque at 23 rpm.
Motors

IP54-Rated DC Gearmotor develops 214 lb-in. torque at 23 rpm.

Accepting any 12 Vdc source including battery power, Model MMP-TM57-12V GP52-195 is rated for 214 lb-in. continuous torque, at 23 rpm, and 443 lb-in. peak torque. Unit requires 7.2 A at 12 Vdc to generate full load torque, maximizing battery charge and allowing low-noise operation. With diameter of 2.24 in. and length of 7.75 in., reversible gearmotor has 12 mm dia, 25 mm long keyed output shaft,...

Read More »
Push-Rod Style Ballscrew Linear Actuator is IP65-rated.
Actuators

Push-Rod Style Ballscrew Linear Actuator is IP65-rated.

Thomson T60 precision ballscrew linear actuator features 75 x 60 mm housing and 38 mm dia hard chromed steel extension tube for selectable travel up to 1,500 mm, direct force to 1,000 N, speeds to 300 mm/sec, and acceleration to 8 m/secÂ-². Maximum input speed of product is 3,000 rpm. Unit is available with choice of 25 mm dia ballscrews with leads of 5, 10, 25, or 50 mm, offering 0.05 mm...

Read More »
Hooks

Campbell-Republic Crain & Hoist Features Crosby Group's, Alloy Master Links

Campbell-Republic Crain & Hoist Corp. has been a distributor of crane equipment, accessories, parts & supplies for over 50 years. We provide equipment, parts & supplies including hoists, trolleys, slings, wire rope custom assemblies, rigging equipment & accessories. We also provide lifting parts & supplies, wire rope terminations, grip clips, mooring sockets, hooks, shackles, sling fittings,...

Read More »

All Topics

COVID-19 Response Suppliers COVID-19 Response:
Can Your Company Help Provide Critical Supplies?

We are using the power of our platform to aid in the mass shortage of critical supplies. If your company can help provide supplies, capabilities, or materials for products such as N-95 Masks and Tyvek SuitsPlease let us know.

COVID-19 Response Suppliers