Mechanical Components and Assemblies

Enclosed Track System carries monorails.
Tracks

Enclosed Track System carries monorails.

KBK Alu systems can suspend monorails and suspension cranes. Made from anodized, corrosion resistant aluminum, high load bearing track sections are available in 120 and 180 sizes: 120 has weight capacity of 750 lb while 180 has weight capacity of 1500 lb, both with 10 feet between hanger supports. Both sizes have grooves for fitting accessories to top of rack.

Read More »
Network Equipment

Analog I/O connects via network.

Additions to CompactBlock(TM) LDX I/O include analog and temperature blocks, plus networking. Analog blocks bring in current and voltage data from valves, pressure sensors, and related field devices. Temperature blocks accept signals from T/Cs and RTDs, and provide scaling for different device types allowing module to convert signal from any standard T/C or RTD into Fahrenheit or Celsius grade...

Read More »
Pneumatic Cylinders

Pneumatic Cylinders are available in 2.5 and 4 mm diameters.

Miniature roundline cylinders feature corrosion resistant finish and service life of 3,000,000 cycles before replacement is required. No fittings are required to install cylinders, which have just one barbed air connection. Units are suitable for applications requiring fast repetitive actions, such as function and life testing manually operated products including mobile phones, calculators, and...

Read More »
Seals require low closure force.
Hydraulic / Pneumatic / Radial Shaft Seals

Seals require low closure force.

FF354-65 white perfluorinated elastomer (FFKM) seals offer low durometer of 65. Soft properties allow for installation of o-rings and other seals into groove shapes such as dovetails and radius corner designs. FF354-65 seals resist compression set and offer temperature resistance up to 600 deg F. Chemical-resistant material is suitable for use in semiconductor fabrication, pharmaceutical...

Read More »
Ground Pin and Solid Blades feature crimp ears.
Blades

Ground Pin and Solid Blades feature crimp ears.

U-shaped ground pin and solid blades are supplied in strip form. They are made from plain- or tin plated-brass, and are used for hospital grade connectors and other critical applications. Crimp ears increase wire attaching speeds. Available in sizes for crimping 18 to 10 ga wire, units eliminate need for soldering process. Blades are UL 1659 certified.

Read More »
Sealants

Rubber Seal always returns to original profile.

Clean Seal Plus closed cell foam rubber seal can be compressed up to 10 percent of its original profile and will expand back to its original shape and size. Rubber sealant is resistant to water absorption and heat. Product, available in various shapes and sizes, is also offered with 3M heat activated tape.

Read More »
Rodless Cylinders are short, thin, and light.
Cylinders

Rodless Cylinders are short, thin, and light.

HORV Series are shorter, thinner, and lighter than company's conventional rodless cylinders of equal bore and stroke. Block type end cap eliminates need for mounting brackets and zero stroke dimension results in dead stroke that is 35% shorter than band-type rodless cylinders. Lightweight body places no loads on actuator axis or stand, even when using Y-Z axis. Cylinders are available with NPT...

Read More »
Fittings eliminate leaks in hydraulic systems.
Mechanical Seals

Fittings eliminate leaks in hydraulic systems.

O-ring face-seal fittings, available in 23 configurations and 35 different size combinations, permit operating pressures as high as 6,000 psi. They can be connected to range of tubing grades by silver brazing. Fittings are suitable for sub-zero to high-temperature applications, and are resistant to vibration and shock conditions. They meet or exceed design and performance requirements of SAE...

Read More »
Shaft Couplings

Controller converts fluid coupling into transmission.

Model PCB microprocessor based circuit board acts as supervisor for company's KPTO fluid coupling. Controller sends analog signals of power and output speed, and digital signals for maximum slip, slip threshold, maximum temperature, maximum and minimum oil pressure, and solenoid valve on/off status. Slip threshold can be set by potentiometer. Controller reduces energy consumption, improves...

Read More »
Locon Sensors Withstand Extreme Temperatures
Sponsored

Locon Sensors Withstand Extreme Temperatures

Locon Sensor Systems offer robust sensor solutions for even the most severe environmental conditions. Their line of high-temp inductive sensors and their cylindrical photoelectric series can operate in temperatures up to 250 degrees Celsius. See our video to learn more.

Read More »

All Topics