Material Handling & Storage

Septimatech Group Inc. Introduces The Unison(TM) Guide Rail Adjustment Solution!

Septimatech Group Inc. Introduces The Unison(TM) Guide Rail Adjustment Solution!

Unison(TM) Guide Rail Adjustment Solution provides rapid line changeover with consistent, accurate and repeatable set-up. Change up to 100 feet of guide rail including corners from a single position without pneumatics. This unique concept offers rapid line changeover solutions and packaging line enhancements. Through continuous design and engineering improvement practices, Septimatech is...

Read More »
Wire Dispensing System speeds wire changeover.

Wire Dispensing System speeds wire changeover.

Constructed with heavy-duty extruded aluminum, Non-Stop(TM) Wire Dispensing System utilizes process that joins end wire from empty drum with start wire of next full drum. Smooth operating wire guide arm handles wire transfer during automatic change, with no manual operator action required. With Butt Welder, both butt welding and flash removal operation take seconds. System works with 1- or...

Read More »
Chemical Dispensing System has quick disconnect design.

Chemical Dispensing System has quick disconnect design.

DrumQuik-® PRO enables safe extraction of chemicals from drums, jerry cans, and other bulk transfer containers while reducing spills and enhancing workplace safety. Closed-system design combines recyclable bung closure and dip-tube with reusable quick disconnect coupler into one integrated unit, ensuring both sides are sealed from point-of-origin to point-of-use. Built-in vent port allows...

Read More »
Frictionless Systems move and position heavy loads.

Frictionless Systems move and position heavy loads.

Using 0.005 in. of nearly frictionless air to lift loads, Aero-Planks offer flexible movement and can balance uneven loads with single air-pressure regulator. Units offer omnidirectional movement and can float loads down production lines as weights increase. Since they do not require permanent in-floor fixtures, travel paths can be changed as needed. Options such as operator handles, guide or...

Read More »
Dispense Valve prevents dripping and controls volume.

Dispense Valve prevents dripping and controls volume.

Designed for fluid control of level-seeking materials, Model 2600-001-006/7 Tip-Seal-® dispense valve consists of double-acting actuator, 13.7 in. extension nozzle, and carbide Tip-Seal needle to prevent dripping at shut-off. For high-volume fluid transfer, valve can flow up to 6 gpm with 0.406 in. orifice nozzle. Along with 29:1 air-to-fluid power ratio for flow control, product has -¾ in. NPT...

Read More »
Vertical Reciprocating Conveyors reduce power consumption.

Vertical Reciprocating Conveyors reduce power consumption.

Driven by belt or chain, vertical reciprocating conveyors suit applications where items need to be moved between levels. Counterweighted lift mechanism minimizes hp and power requirements, while shaft-mounted drive reduces maintenance requirements. Load and unload points can be incorporated at any height and on any side, permitting Z, C, or right-angle flow. Load capacities are available to 6,000...

Read More »
Mini-Parallel Grippers suit space-restricted applications.

Mini-Parallel Grippers suit space-restricted applications.

Used in electronic and packing applications, MGP800 Series uses hardened steel flat guide to ensure optimal force and moment resistance. Magnetic sensors can be mounted to sense jaw position, allowing for positive feedback. Manifolding through bottom mounting surface eliminates need for air fittings and allows grippers to be mounted in close array. Series comes in 5 sizes, from 12 x 10 x 20 mm to...

Read More »

Coolant Maintenance System is designed for in-ground sumps.

Featuring tramp oil removal and solids filtration to sub-micron levels, CoolantLoop(TM) works with in-ground coolant sumps and large above-ground coolant tanks. Continuous skimming from pit or tank removes floating tramp oil, keeping coolant clean and healthy. System concentrates and removes floating tramp oil and settleable solids solely by gravity. Fine filtration to micron levels and magnetic...

Read More »

ARTEL to Launch Liquid Handler Performance Verification Service at Lab Automation 2007

Provides Independent Assurance of Data Integrity for all Models Westbrook, ME (October 16, 2006) - To provide laboratories with robust, timely and efficient assurance of their equipment performance, ARTEL is announcing its new Liquid Handler Performance Verification service at Lab Automation 2007, Palm Springs Convention Center, CA, January 27-31, Booth #438. Part of the company's new LDQATM...

Read More »

Security Bag provides 2-way sealing with void messaging.

Available in single/dual compartment configurations, UltraVOID(TM) 2 incorporates press-to-close and foldover sealing options for added security. Closure system is backed by visual void messaging when seals are breeched. Bag is made of thick gauge, 3-layer coextruded film blend, and uses -½ in. pouch seal on vertical sides for puncture and tamper resistance. Bag, receipt, and bottom pocket are...

Read More »
Basalt America Announces Stronger, Lighter, and Corrosion-Free FRP's (Fiber Reinforced Polymers)
Sponsored

Basalt America Announces Stronger, Lighter, and Corrosion-Free FRP's (Fiber Reinforced Polymers)

Fiber Reinforced Polymers (FRP), represents a truly groundbreaking advancement in structural reinforcement. Lightweight, strong, and green, they are changing the way the construction industry thinks about rebar. Unlike steel, FRPs don't rust and are far stronger than standard rebar. To learn why Fiber Reinforced Polymers are poised to change the way the world builds, see our video.

Read More »

All Topics