Igniters

Ignitor Chip Resistor features firing energy down to 1.5 mJ.
Igniters

Ignitor Chip Resistor features firing energy down to 1.5 mJ.

Available in wraparound or flip chip versions as well as integrated on PCB substrate, Sfernice MEPIC Massive Electro-Pyrotechnic Ignitor Chip Resistor offers Joule effect or flash ignition for fast firing times down to 250 Â-µs. Unit converts electrical energy into heat energy in precise electro-thermal profile for purpose of initiating series of pyrotechnic events in controlled energetic...

Read More »
Miscellaneous Controls

Specialty Igniters accommodate heavy fuel oil applications.

CoronaArc Power Pack is available in 3 models - 12 JOULE, RAPID FIRE; 12 JOULE, STANDARD-FIRE; and 12 JOULE - respectively suited for heavy fuel oil, relatively volatile heavy fuel oil applications, and ignition of No. 2 oil main nurners or gas/oil fuel igniters. While RAPID FIRE produces 12-15 pulses/sec at 600 W, STANDARD-FIRE produces 4-6 pulses/sec at 300 W, and 12 JOULE produces 4-6...

Read More »
Igniters

Ignitor Assemblies target CO2 laser industry.

Intended for CO2 lasers used for cutting, marking, scribing, and engraving, Gas Discharge Igniter Assemblies include igniter ceramic manufactured with 99.5% high-purity alumina, sleeve, and flange. Ceramic-to-metal seals offer impact and thermal shock resistance, and can maintain hermeticity in variety of harsh conditions, including corrosive environments and temperature extremes up to...

Read More »
Thyristors offer high-temperature operation.
Silicon Controlled Rectifiers (Thyristors)

Thyristors offer high-temperature operation.

With max junction temperature of 125°C, Multipulse(TM) SIDAC Series is capable of switching speeds exceeding 8 kHz. Units optimize speed and consistency of lamp lighting by allowing multiple sparks per half cycle. During lamp outages, ignitor functions in active mode or in continuous operation until lamp is replaced. Suited for metal halide and high-pressure sodium lighting, devices...

Read More »
Gas Ignition Controls - Intermittent Pilot
Miscellaneous Controls

Gas Ignition Controls - Intermittent Pilot

9/14/2006 Ashland, The new Fenwal Series 35-63 Intermittent Pilot (IP) Gas Ignition Controls for 24 VAC power are now in production. They are specifically designed for HVAC, commercial cooking equipment, boilers, furnaces and other gas fired applications using the spark-to-pilot" technique. The Fenwal Series 35-63 IP Gas Ignition Controls are microprocessor-based for precise, repeatable timing...

Read More »
Igniters

Flare Ignition System offers uninterrupted performance.

WindPROOF(TM) InstaFire(TM) is engineered with rapid response capability as well as 3 levels of detection and relighting redundancies. Integration of WindPROOF technology enables operation in extreme weather conditions, including high winds. Consuming as little as 45 scfh of natural gas, system exceeds American Petroleum Institute Standard 537 recommendations.

Read More »
Lamp Re-Igniters ensure rapid cold start and hot restart.
Igniters

Lamp Re-Igniters ensure rapid cold start and hot restart.

Rapid Smart Start RSS-50-150 Series speeds starting and re-starting of high-pressure sodium light sources in outdoor areas. Units connect near lamp socket, ensuring illumination of 52/55 V HPS lamps between 50-150 W. They consume less than .3% of power during normal lamp operation and withstand moderate under- or over-voltages. Re-igniters are suited for pole- and building-mounted commercial and...

Read More »
Gas Ignition Control runs on 120 Vac, 50/60 Hz.
Igniters

Gas Ignition Control runs on 120 Vac, 50/60 Hz.

Model 35-73 Intermittent Pilot Gas Ignition Control is microprocessor-based and polarity insensitive. Featuring repeatable timing sequences, it provides TFI times up to 120 sec, single spark and sense and remote flame sense options, thermostat/power off and automatic reset options, and on-board diagnostics with LED output. CSA certified unit is suitable for controlling pilot and main gas valves,...

Read More »
Locon Sensors Withstand Extreme Temperatures
Sponsored

Locon Sensors Withstand Extreme Temperatures

Locon Sensor Systems offer robust sensor solutions for even the most severe environmental conditions. Their line of high-temp inductive sensors and their cylindrical photoelectric series can operate in temperatures up to 250 degrees Celsius. See our video to learn more.

Read More »

All Topics