Fluid & Gas Flow Equipment

Fittings eliminate leaks in hydraulic systems.
Mechanical Seals

Fittings eliminate leaks in hydraulic systems.

O-ring face-seal fittings, available in 23 configurations and 35 different size combinations, permit operating pressures as high as 6,000 psi. They can be connected to range of tubing grades by silver brazing. Fittings are suitable for sub-zero to high-temperature applications, and are resistant to vibration and shock conditions. They meet or exceed design and performance requirements of SAE...

Read More »
Solenoid Valve mounts to multi-directional valves.
Valves

Solenoid Valve mounts to multi-directional valves.

Profibus PA solenoid valve class A discrete output device conforms to PA profile V3.042 and can be mounted to 2-way, 3-way, and 4-way valves. Its diagnostics include cycle time, travel time, self-calibration, open and short circuit detection, manufacturer information, and tag and serial numbers. Equipped with manual override, unit is approved to FM, CSA, Cenelec, and Profibus PA conformance.

Read More »
Sump Pumps replace other pumps without plumbing changes.
Pumps

Sump Pumps replace other pumps without plumbing changes.

SP33 1/3 hp and SP50 1/2 hp sump pumps have cast iron vortex impeller, stainless steel shaft, silicon carbide seals, thermal overload protection, and permanent split capacitor motor. Piggyback-mounted switch eliminates need to pull pump to check for pump failure. Adjustable vertical or swing floats are available to accommodate varying conditions. Pumps interchange with competing sump pump models,...

Read More »
Portable Air Compressor has 30 gal receiver tank.
Air / Gas Compressors

Portable Air Compressor has 30 gal receiver tank.

Two-stage air compressor has 11 hp gasoline engine with 15.7 in. fly wheel for extra cooling and longer life. It has cast iron cylinders, large canister intake filters, 14 ga powder coated belt guard, powder coated roll cage, 4 pneumatic tires, powder coated 30 gal ASME certified tank receivers, stainless steel braided discharge hose, 2 gauges for tank and outlet pressure, manual drain valve for...

Read More »
Hydraulic Piston Pump works quietly at high pressures.
Pumps

Hydraulic Piston Pump works quietly at high pressures.

Compact XL75 open circuit 75 cc/rev displacement pump operates at 4,060 psi. It has smooth, rounded construction, with no drum-type surfaces to amplify noise. Pump has hydrostatic bearings and O-ring seals rather than gaskets. Applications include plastics machines, die casters, presses, power units, aerospace test stands, tractors, front end loaders, scrapers, dozers, heavy duty fork lifts, haul...

Read More »
Hose Pump provides pressure to 230 psi.
Pumps

Hose Pump provides pressure to 230 psi.

Compact and rugged seal-less Verderflex pump has no flaps or valves and few wearing parts for easy maintenance. It provides capacity from 0.1 to 350 gpm, pressure to 230 psi, and suction lift to 30 ft. Closed coupled unit provides simple hose replacement.

Read More »
Connector System suits wire harness assemblies.
Connectors

Connector System suits wire harness assemblies.

Model 4.2 Power Economy (PE) series connector system is suited for wire to wire applications that require 4.2 x 4.2 mm centerline spacing. Plastic connector mates and unmates while maintaining positive-latch design. Unit is available in 2 to 24 positions and accommodates receptacle housing with either panel mount or free hanging plug housing. Connector mates with AMP-DUAC connectors and other...

Read More »
Pumps meter chemicals and solutions.
Pumps

Pumps meter chemicals and solutions.

JaecoPak(TM) and Hi-Flo(TM) packed-plunger metering pumps are available in simplex and duplex models. JaecoPak pump capacities range from 0.38 to 150 gph while Hi-Flo pump capacities range from 20 to 682 gph at pressures up to 7,200 psi. By varying piston stroke length, both pumps are adjustable from 0 to 100% of maximum capacity for turn-down ratio of 10:1. Liquid ends are available in 316...

Read More »
Lead Assemblies handle high voltages.
Connectors

Lead Assemblies handle high voltages.

Hi/Mate 12 gauge contact lead assemblies for MIL-C-38999 Series I, III, and IV connectors withstand up to 13.5 kVdc, commonly found in densely packaged, high-voltage power supplies, CRTs, and TWTs. Assemblies are terminated with Hi Voltage FEP cables. Insertion and removal procedures use same tools as standard 38999 connector. Lead assemblies are electrically isolated from connector shell and can...

Read More »

All Topics

COVID-19 Response Suppliers COVID-19 Response:
Can Your Company Help Provide Critical Supplies?

We are using the power of our platform to aid in the mass shortage of critical supplies. If your company can help provide supplies, capabilities, or materials for products such as N-95 Masks and Tyvek SuitsPlease let us know.

COVID-19 Response Suppliers