Electronic Drivers

Multi-String LED Drivers promote power efficiency for displays.
Electronic Drivers

Multi-String LED Drivers promote power efficiency for displays.

Intelligent multi-string LED drivers use efficiency optimizer (EO) technology to decrease power consumption to lowest practical level. Capabilities enable LCD TVs to achieve 10M:1 dynamic contrast and minimal motion-blur. ICs also provide over 10,000:1 PWM dimming range for PC monitors and industrial displays. In solid state lighting applications, ICs and MCUs allow dynamic white-point setting,...

Read More »
Electronic Drivers

Half-Bridge Gate Driver IC supports GaN power FETs.

Optimized for use with enhancement-mode GaN power FETs in high-voltage power converters, 100 V Model LM5113 regulates high side floating bootstrap capacitor voltage at approximately 5.25 V. Device features independent sink and source outputs for flexibility of turn-on strength with respect to turn-off strength. Low impedance pull down path of 0.5 W provides reliable turn-off mechanism. Housed in...

Read More »
Half-Bridge Gate Driver IC reduces component count, PCB area.
Electronic Drivers

Half-Bridge Gate Driver IC reduces component count, PCB area.

Supplied in 10-pin, 4 x 4 mm LLP, LM5113 high- and low-side GaN FET driver lends to density of power brick and communications infrastructure equipment. This 100 V bridge driver IC regulates high side floating bootstrap capacitor voltage at ~5.25 V to drive enhancement-mode Gallium-Nitride (GaN) power FETs without exceeding max gate-source voltage rating. Other features include independent sink...

Read More »
LED Backlight Driver IC meets needs of medium/large displays.
Electronic Drivers

LED Backlight Driver IC meets needs of medium/large displays.

Suited for backlighting LCD monitors and TVs, A8516 WLED/RGB driver helps designers reduce component count by integrating boost controller to drive external MOSFET and 6 internal current sink channels capable of up to 80 mA each. Channels can be combined to achieve higher currents, and boost converter operates in constant frequency (programmable) current mode control. LED sink current is set by...

Read More »
Electronic Drivers

RGB LED Driver targets portable projectors.

Accepting 2.7-5.5 V input voltage, 2 A Model LM3435 drives 3 common anode RGB high-brightness LEDs sequentially with single inductor, powering one after another at 60 Hz and above to match LCoS or DLP devices. Switching-mode, constant current regulator integrates all active components, including N-Channel main MOSFET, P-Channel synchronous MOSFET, and 3 N-channel pass switches. Level of current...

Read More »
Single-Inductor, 2 A RGB LED Driver suits portable projectors.
Electronic Drivers

Single-Inductor, 2 A RGB LED Driver suits portable projectors.

Supplied in 40-pin thermally enhanced LLP, LM3435 drives 3 common anode RGB high-brightness LEDs sequentially with one inductor. LEDs are powered one after another at 60 Hz and above to match operation requirements of liquid crystal on silicone (LCoS) or digital light processing (DLP) image devices. Along with IÂ-²C control interface, this switching-mode constant current regulator integrates...

Read More »
Electronic Drivers

White LED Driver features automatic phase shifting.

Suited for LCD backlighting in tablet computers, Model AAT1451 drives up to 4 LED strings at up to 93% efficiency. Device uses 32 kHz PWM operating frequency to ensure silent operation and has switching frequency of 600 kHz to 1 MHz. To ensure accurate backlight color temperature and uniform brightness, driver has 4 current sinks that are programmable up to 30 mA per string at ±2% accuracy...

Read More »
Electronic Drivers

Linear LED Driver facilitates area-lighting design.

Integrating 70 V, 1.5 A N-channel MOSFET and featuring input range of 6-70 V, Model LM3466 uses 1 resistor and 1 capacitor to drive LED string from any AC/DC constant-current power supply. Dynamic current equalizing control scheme enables communication between each LED driver to divide current amongst multiple active LED strings. During open string state, each LM3466 automatically equalizes...

Read More »
LED Driver equalizes current between multiple LED strings.
Electronic Drivers

LED Driver equalizes current between multiple LED strings.

Operating from 6-70 V input, LM3466 conducts up to 1.5 A and incorporates 70 V, 1.5 A N-Channel MOSFET. Easy integration enables LM3466 along with one resistor and one capacitor to drive each LED string from any AC/DC constant-current power supply. Complete fixture can be constructed by repeating strings in parallel, and dynamic current equalizing control scheme enables communication between each...

Read More »
Step Up LED Drivers are integrated into 2 x 1 mm package.
Electronic Drivers

Step Up LED Drivers are integrated into 2 x 1 mm package.

Model AMLB-Z step up LED drivers feature 4:1 input range of 9-36 Vdc that steps up to output voltage range of 14-48 Vdc as well as constant output currents from 150-700 mA. Ripple and noise are 350 mV p-p. Modular and RoHS-compliant, units also have remote ON/OFF function, continuous short circuit protection, and adjustable PWM and analog dimming functions to ensure consistent brightness.

Read More »

All Topics