Electronic Converters

Electronic Converters

ADC dissipates only 127 mW of power.

Operating from 1.8 V analog supply, LTC2261 14-bit 125 Msps ADC offers SNR performance of 73.4 dB and SFDR of 85 dB at baseband. Low jitter of 0.17 psRMS allows undersampling of IF frequencies with noise performance, while digital outputs can be set to full rate CMOS, double data rate CMOS, or double data rate LVDS. Offered in 6 x 6 mm QFN package, unit randomizes digital output before it is...

Read More »
Electronic Converters

Video Server can stream digitized video over IP networks.

Featuring MPEG-4/Motion-JPEG format video compression, 4-channel Model OVS-400 of OWL series converts analog video signals into IP video streams. Product supports 12 Vdc power input, video output in all type of resolutions including full D1/CIF/QCIF, two-way audio, 2 sets of alarm input/output via terminal block connection, and offers manually bit rate control from 28 Kbps up to 3 Mbps. Built-in...

Read More »
Electronic Converters

SOC helps build digital terrestrial broadcast receivers.

Designed for tuners that enable viewing of digital terrestrial broadcasts on analog televisions, EMMA(TM)2TS system-on-chip incorporates Full SegNote OFDM channel decoder compliant with Japanese Integrated Services Digital Broadcasting-Terrestrial (ISDB-T)standard. It also includes MPEG2 decoder, image display, video/audio D/A converter, and smartcard interface. SOC suppresses power consumption...

Read More »
I/O Wiring Conversion System Helps PLC Users with Phased Migration to Rockwell Automation Integrated Architecture
Electronic Converters

I/O Wiring Conversion System Helps PLC Users with Phased Migration to Rockwell Automation Integrated Architecture

Helps minimize wiring errors and reduce labor costs when migrating to newer programmable automation control systems MILWAUKEE, Nov. 13, 2008 - Rockwell Automation has developed an I/O wiring conversion system that helps users migrate existing control platforms to the AllenÂ-¬Bradley ControlLogix programmable automation controller-based I/O platform. The system is part of the Rockwell...

Read More »
Power Boost Converters require only 8.5 µA quiescent current.
Electronic Converters

Power Boost Converters require only 8.5 µA quiescent current.

Models LT8410/-1 low-noise micropower boost converters with integrated power switches, Schottky and catch diodes, and output disconnect circuitry are housed 2 x 2 mm DFN package. Integrated high value (12.4M/0.4M) output feedback divider resistors enable device to regulate 16 V output with no load with less than 30 Â-µA of quiescent current. Wide 2.6-16 V input range enables them to operate...

Read More »
Electronic Converters

Time-to-Digital Converter offers 5 picosec timing resolution.

Model U1050A-002 of U1050A line of Acqiris time-to-digital converters has measurement range of up to 20 sec and ratio of 1:4.109. Module can operate in either single-start or multi-start acquisition modes with timing information on all 13 independent channels encoded relative to common channel. Time measurement on unit can be based on either internal low jitter of less than 3 ps rms, high...

Read More »
High Voltage Down Converter allows 5-10 kV transmission.
Electronic Converters

High Voltage Down Converter allows 5-10 kV transmission.

Featuring direct solid-state switching, PowerMod(TM) provides down conversion of 10-20 kW, with conversion to 100-600 V at point-of-load undersea. It maintains 90% efficiency, with constant transmission over length of cable up to 100 km and up to hundreds of kilometers using multiple nodes. Applications include remote undersea powering of motors, data repeaters, instruments for oil exploration,...

Read More »
Analog Signal Converter offers less than 5 ms response time.
Electronic Converters

Analog Signal Converter offers less than 5 ms response time.

Featuring 16-32 Vdc input range and 0-10 Vdc to ±200 mA output, Model IC-DR-23 converts any analog or PWM signal to suit application. DIN rail-mounted unit includes short circuit protection and reverse polarity protection, as well as diagnostic LEDs to indicate operational status. Operating from -40 to 85°C, converter consumes 20 mA at 24 Vdc, no load. With IP40-rated housing and...

Read More »
Electronic Converters

Modbus Modules control analog output using serial port.

Designed for industrial motion control, D3000M series of digital-to-analog devices communicate using Modbus RTU over RS-232C or RS-485 link. Input-to-Output isolation is 500 Vrms and units offer measurement resolution of 12 bits. They include 8-bit CMOS microcomputer that performs scaling and calibration tasks in software. Packaged in 3.60 x 2.45 x 0.85 in. ABS case, products are available in 16...

Read More »
RS-232 to USB Interface Converter OM-CONV-USB Series
Electronic Converters

RS-232 to USB Interface Converter OM-CONV-USB Series

The OM-CONV-USB includes driver software and has a data transfer rate of >1Mbps. This product is powered from the USB cable with no external power required. Simply install the driver software into the PC and connect the converter into your USB port. The device is immediately recognized by the system. At that point, simply connect the converter to your serial device such as a modem, scale, serial...

Read More »

All Topics

COVID-19 Response Suppliers COVID-19 Response:
Can Your Company Help Provide Critical Supplies?

We are using the power of our platform to aid in the mass shortage of critical supplies. If your company can help provide supplies, capabilities, or materials for products such as N-95 Masks and Tyvek SuitsPlease let us know.

COVID-19 Response Suppliers