Electronic Converters

Electronic Converters

SOC helps build digital terrestrial broadcast receivers.

Designed for tuners that enable viewing of digital terrestrial broadcasts on analog televisions, EMMA(TM)2TS system-on-chip incorporates Full SegNote OFDM channel decoder compliant with Japanese Integrated Services Digital Broadcasting-Terrestrial (ISDB-T)standard. It also includes MPEG2 decoder, image display, video/audio D/A converter, and smartcard interface. SOC suppresses power consumption...

Read More »
I/O Wiring Conversion System Helps PLC Users with Phased Migration to Rockwell Automation Integrated Architecture
Electronic Converters

I/O Wiring Conversion System Helps PLC Users with Phased Migration to Rockwell Automation Integrated Architecture

Helps minimize wiring errors and reduce labor costs when migrating to newer programmable automation control systems MILWAUKEE, Nov. 13, 2008 - Rockwell Automation has developed an I/O wiring conversion system that helps users migrate existing control platforms to the AllenÂ-¬Bradley ControlLogix programmable automation controller-based I/O platform. The system is part of the Rockwell...

Read More »
Power Boost Converters require only 8.5 µA quiescent current.
Electronic Converters

Power Boost Converters require only 8.5 µA quiescent current.

Models LT8410/-1 low-noise micropower boost converters with integrated power switches, Schottky and catch diodes, and output disconnect circuitry are housed 2 x 2 mm DFN package. Integrated high value (12.4M/0.4M) output feedback divider resistors enable device to regulate 16 V output with no load with less than 30 Â-µA of quiescent current. Wide 2.6-16 V input range enables them to operate...

Read More »
Electronic Converters

Time-to-Digital Converter offers 5 picosec timing resolution.

Model U1050A-002 of U1050A line of Acqiris time-to-digital converters has measurement range of up to 20 sec and ratio of 1:4.109. Module can operate in either single-start or multi-start acquisition modes with timing information on all 13 independent channels encoded relative to common channel. Time measurement on unit can be based on either internal low jitter of less than 3 ps rms, high...

Read More »
5 Questions to Ask When Choosing a Custom Glass Manufacturer
Sponsored

5 Questions to Ask When Choosing a Custom Glass Manufacturer

Due to the inherent complexity of glass fabrication, many professionals seeking glass services know exactly what kind of part is needed, but are unclear on the intricacies of the actual manufacturing process. PEG's exclusive guide is designed to help professionals navigate the custom glass manufacturing process with valuable information.

Read More »
High Voltage Down Converter allows 5-10 kV transmission.
Electronic Converters

High Voltage Down Converter allows 5-10 kV transmission.

Featuring direct solid-state switching, PowerMod(TM) provides down conversion of 10-20 kW, with conversion to 100-600 V at point-of-load undersea. It maintains 90% efficiency, with constant transmission over length of cable up to 100 km and up to hundreds of kilometers using multiple nodes. Applications include remote undersea powering of motors, data repeaters, instruments for oil exploration,...

Read More »
Analog Signal Converter offers less than 5 ms response time.
Electronic Converters

Analog Signal Converter offers less than 5 ms response time.

Featuring 16-32 Vdc input range and 0-10 Vdc to ±200 mA output, Model IC-DR-23 converts any analog or PWM signal to suit application. DIN rail-mounted unit includes short circuit protection and reverse polarity protection, as well as diagnostic LEDs to indicate operational status. Operating from -40 to 85°C, converter consumes 20 mA at 24 Vdc, no load. With IP40-rated housing and...

Read More »
Electronic Converters

Modbus Modules control analog output using serial port.

Designed for industrial motion control, D3000M series of digital-to-analog devices communicate using Modbus RTU over RS-232C or RS-485 link. Input-to-Output isolation is 500 Vrms and units offer measurement resolution of 12 bits. They include 8-bit CMOS microcomputer that performs scaling and calibration tasks in software. Packaged in 3.60 x 2.45 x 0.85 in. ABS case, products are available in 16...

Read More »
RS-232 to USB Interface Converter OM-CONV-USB Series
Electronic Converters

RS-232 to USB Interface Converter OM-CONV-USB Series

The OM-CONV-USB includes driver software and has a data transfer rate of >1Mbps. This product is powered from the USB cable with no external power required. Simply install the driver software into the PC and connect the converter into your USB port. The device is immediately recognized by the system. At that point, simply connect the converter to your serial device such as a modem, scale, serial...

Read More »
Electronic Converters

Signal Path Solution suits DAQ systems, STBs, and radar.

At 248 MHz, ADC10D1000 provides spurious-free dynamic range(SFDR) performance of 66 dBc and 9.1 effective number of bits. This 2 GSPS single/1 GSPS dual ADC runs off single supply voltage and consumes 2.8 W. At 2.5 GHz, LMH6554 wideband fully differential amplifier drives 10-bit ADC10D1000 and provides 0.1 dB gain flatness up to 800 MHz, SFDR of 72 dBc at 250 MHz, and input voltage noise...

Read More »
Electronic Converters

Signal Simulator suits RF link and range setup applications.

Combining digital wideband waveform modulator with RF upconverter and link test capabilities, SE-4255 RF Exciter and Test Signal Simulator produces transmission-ready signals in Baseband, Upper L-, Lower L-, and both transmit and receive S-Band frequency ranges. It features Auto-BERT, automated test application for construction and display of waterfall performance curves. Product suits mobile...

Read More »

All Topics