Electronic Converters

Dual-Channel DAC facilitates power-supply margin testing.
Electronic Converters

Dual-Channel DAC facilitates power-supply margin testing.

Housed in 8-pin Â-µSOP, 7-bit I²C-controlled Model DS4432 features 2 output channels, each providing fine control of DC-DC power supply by sinking or sourcing current directly into power supply's feedback node. Full-scale output currents are set between 50-200 µA using one external resistor for each channel. Through I²C bus, output currents can then be set to any of...

Read More »
Electronic Converters

ADCs simplify power-line monitoring system design.

Suited for utility subsystem control, 8-channel AD7606 (16-bit) and AD7607 (14-bit) simultaneous-sampling ADCs achieve SNR of 90 dB and offer optional oversampling mode that helps reduce code spread and enhance anti-alias rejection. Multi-channel integration facilitates 3-phase I/V measurement and neutral monitoring, while true bipolar analog input ranges of ±5 and ±10 V allow for...

Read More »
Electronic Converters

Integrated Ground Referenced DACs free up PCB area.

Delivering 106 dB SNR with optimized mute and crosstalk performance, WM8523 and WM8524 deliver audio performance required in consumer electronics products while eliminating need for 18 external components. Charge pump architecture generates pop-free, 2 Vrms stereo output signal from single standard 3.3 V rail without separate op-amps. Both products can driving 1 kW line load and generate...

Read More »
DACs suit industrial control and automation applications.
Electronic Converters

DACs suit industrial control and automation applications.

Offered in 3 x 3 mm package, 16-bit MAX5138 and 12-bit MAX5139 integrate voltage reference and are pin- and software-compatible. Power-down feature minimizes power consumption to 200 nA, while internal buffer optimizes load regulation and transition-glitch suppression for DAC output. Pin-programmable, zero/midscale DAC output ensures output powers up to desired state, even during loss-of-power...

Read More »
FMC Mezzanine Cards support Xilinx Virtex-6 FPGAs.
Electronic Converters

FMC Mezzanine Cards support Xilinx Virtex-6 FPGAs.

FPGA Mezzanine Card (FMC/VITA 57) modules include 3 GSps, 8-bit, dual-channel ADC512 as well as 1.5 GSps, 8-bit, 4-channel ADC513, which both support up to 1,500 MSps data throughput per channel. Products eliminate data bottlenecks by supporting bandwidths in excess of 6 B/s with direct, low-latency connections to host FPGAs, including Xilinx® Virtex®-6 FPGAs. Air- and...

Read More »
Analog-to-Digital Converter is cascadable to 32 channels.
Electronic Converters

Analog-to-Digital Converter is cascadable to 32 channels.

Housed in 38-pin TSSOP package, 4-channel 24-bit MAX11040 provides compensation for phase shift caused by resistor dividers, transformers, or filters at analog inputs through programmable delay of 0-333 Â-µsec. Eight units can be daisy-chained to provide sampling capacity of up to 32 channels. With minimum SINAD of 90 dB and SFDR of 91 dB, ADC is suited for power-grid-protection equipment,...

Read More »
Downconverting Mixer features on-chip LO buffer.
Electronic Converters

Downconverting Mixer features on-chip LO buffer.

Designed using monolithic SiGe BiCMOS process, 2.0-3.9 GHz MAX19996A provides fully integrated downconversion channel, with +24.5 dBm IIP3, 8.7 dB conversion gain, and 9.8 dB typical noise figure. Unit features 2LO-2RF spurious rejection of 67 dBc for RF level of -10 dBm, and 62 dBc for level of -5 dBm. Housed in 5 x 5 mm, 20-pin TQFN package, device supports both high- and low-side LO injection...

Read More »
Up/Downconverting Mixer operates from 850-1,550 MHz.
Electronic Converters

Up/Downconverting Mixer operates from 850-1,550 MHz.

When configured as downconverter, Model MAX2051 provides 35 dBm of IIP3, 24 dBm of IP1 dB, 7.4 dB of conversion loss, and 7.8 dB noise figure. SiGe passive mixer exhibits 2 x 1, 2 x 2, and 3 x 3 spurious suppression, with typical values of 88, 79, and 101 dBc, respectively, over entire 50-1,000 MHz IF band. As upconverter, MAX2051 delivers 33.4 dBm of IIP3, conversion loss of 7.5 dB, and better...

Read More »
Electronic Converters

Analog-to-Digital Converters dissipate 558 mW at 125 Msps.

Providing 4 ADCs in 7 x 8 mm QFN package, quad-channel Series LTC2175 features 14-bit resolution from 25-125 MSps, SNR of 73.4 dB, and SFDR of 88 dB at baseband. Data is output in serial LVDS format to minimize number of data lines. SPI-compatible interface allows users to choose between variety of data settings that minimize digital feedback. Operating from 1.8 V analog and digital supplies,...

Read More »

All Topics