Electronic Converters

IP67-Rated Gateway survives harsh environments.
Electronic Converters

IP67-Rated Gateway survives harsh environments.

Using M12 connectors to interface with industrial automation networks, netBRICK comes in plastic housing and can operate as Slave or Master. Each supported protocol conversion is pre-programmed, facilitating I/O mapping, while electronic component selection ensure resistance to elevated thermal loads as well as sustained operation in areas with varying temperatures between -20 to +70°C....

Read More »
Electronic Converters

IP Surveillance System aids transition from analog to digital.

Delivering mission-critical network connectivity, IP Surveillance System facilitates analog-to-digital migration without need to replace current cabling infrastructure. AT-8100 Series access-edge switches enable SD storage and analytics of video content at edge while connecting local copper devices over fiber at distances up to 1.2 miles. Designed to convert existing analog phone-grade wiring...

Read More »
Electronic Converters

ADC offers 23.9-bit effective resolution at less than 300 µA.

Suited for precision 4-20 mA loop sensor applications, single-channel 24-bit MAX11210 offers 4 general-purpose I/O lines, and integrates buffer amplifiers on analog and reference inputs. Four GPIO lines can be used to control external 16-channel multiplexer, effectively converting MAX11210 into 16-channel ADC. Housed in 16-pin QSOP package, device offers software-programmable oversampling ratio...

Read More »
Electronic Converters

Up-Converter targets microwave and millimeter wave applications.

Consisting of GaAs MMIC I/Q up-converter in SMT ceramic package, Model RFUV5945A accelerates radio design and minimizes board space by integrating I/Q mixer, LO buffer amplifier, and output driver amplifier within 5 x 5 mm outline. Operating across frequencies of 10-16 GHz, device provides single up-converter solution for 11, 13, and 15 GHz microwave radios. DC to 4 GHz IF frequency range ensures...

Read More »
Electronic Converters

16-bit ADC offers sampling rate of 250 MS/sec.

Featuring on-chip IF sampling circuit and buffered analog inputs, Model AD9467 offers 16-bit resolution, spurious-free dynamic range up to 100 dBFs, and signal-to-noise ratio performance of 76.4 dBFS. Signal bandwidths up to 300 MHz enable advances in radar systems, spectrum analyzers, and multi-carrier, multi-mode receiver designs for wireless infrastructure. Housed in Pb-free, 72-lead, LFCSP,...

Read More »
Electronic Converters

Audio DAC integrates stereo line drivers.

Supplied as 14-pin SOIC, CS4354 uses on-chip charge pump to generate negative supply and outputs ground-centered, 2 Vrms filtered line level signal from 5 V supply. This optimizes low-frequency response and audio quality while eliminating need for DC blocking capacitors, mute and pop suppression circuits, and high-voltage power supply. Supporting 24-bit conversion and automatic detection of audio...

Read More »
Electronic Converters

Device Converter simplifies multilayer PCB prototyping.

Actel device converter - DC-AX2000/RTAX2000S-01 allows users to implement commercial Axcelerator® FG896 package during prototyping, and then switch to equivalent CQ352 package for production. Soldered directly onto SMT QFP pads, product is designed to receive AX2000 Actel Axcelerator® Family FPGAs on top and converts pin mapping to RTAX2000S Actel Radiation-Tolerant FPGAs. Unit...

Read More »
Electronic Converters

Low-Power SAR ADC has serial interface, 1 MSPS throughput.

Consuming 13 mW from single 2.5 V supply, 16-bit LTC2383-16 achieves 92 dB SNR and -106dB THD from fully differential +2.5 V input range while maintaining max +2LSB INL and no missing codes. Pin- and software-compatible complementary devices - LTC2382-16 (500 ksps) and LTC2381-16 (250 ksps) - feature sampling architecture that allows ADCs to begin acquiring next sample during current conversion,...

Read More »
Electronic Converters

Analog-to-Digital Converter supports 100 G optical transport.

Implemented in 0.9 V 40 nm CMOS technology, 8-bit Charge-mode Interleaved Sampler ADC supports data rates from 55-65 GS/sec and meets requirements of long-haul links with data rates of 100 Gbps and higher over single wavelength. Four-channel CMOS design allows for integration with coherent receiver digital cores, typically comprising tens of millions of logic gates and multi-terabit data rate...

Read More »
Signal Conditioner converts 4 to 20 mA to frequency.
Electronic Converters

Signal Conditioner converts 4 to 20 mA to frequency.

Offering solution for multiple channel PLC I/O systems, Model 8505 is designed to operate into common 24 V, 7 mA PLC discrete counter input. Converter provides 1-5 kHz output frequency for 4 Â-µA per Hz resolution. Output is linear to 0.01% with accuracy of better than 0.1%. Housed in 3.78 x 1.06 x 1.65 in. plastic case with built-in DIN rail-mounting foot, device features isolated floating...

Read More »

All Topics