Electronic Components & Devices

Male Connectors are designed for use in backplanes.
Electrical Connectors

Male Connectors are designed for use in backplanes.

Type D Vertical Male Connectors are 8+2-row x 25-position headers that provide up to 220 signal contacts evenly distributed on 2 mm grid. They are UL approved and comply with requirement of IEC 917 and IEC 61076-4-101 specifications. Featuring multipurpose center incorporating pre-alignment guides, connectors feature press-fit design for gas-tight connection to PC board and are available in a...

Read More »
Oscillator features frequency range to 156.25 MHz.
Oscillators

Oscillator features frequency range to 156.25 MHz.

F4100 Crystal Oscillator offers standby mode for lower power consumption. Miniature 3.3 V oscillator features operating temperature range of -10°C to 70°C. Frequency stability is +/-100 ppm for all conditions. Output symmetry is 40% to 60% at 1.65 V over entire frequency range of 125 to 156.25 MHz; input current is 60 mA maximum. Unit is suitable for Fibre Channel, SONET, ATM,...

Read More »
Inserter/Extractor has hot stamping area.
Circuit Board Extractors

Inserter/Extractor has hot stamping area.

LP-1107 Inserter/Extractor's positive locking feature ensures secure retention of printed circuit boards and protection of components, circuitry, and connectors. Roll pin configuration locks boards into position, eliminating vibrations and rattles while preventing stress on board and accidental release of cards from connectors. LP-1107 comes with mounting pins, and is available for 1/16 in. thick...

Read More »
Plug End fits appliances and assembles easily.
Electrical Connectors

Plug End fits appliances and assembles easily.

Pre-molded 10-12 AWG Male Bridge provides three-prong plug end for large and small appliance power cords, power tool cords and extension cords. It allows 3 electrical terminals to be crimped at once on assembly line for fast loading of plug overmolds Bridge is available in black or natural nylon. Optional seven-shape blades have retention ledge to maintain firm position during plug molding.

Read More »

All Topics