Electronic Components & Devices

Receptacles support SCSI and FC-AL systems.
Connectors

Receptacles support SCSI and FC-AL systems.

SCA-2 receptacles consist of staggered contact heights which enable hot-plugging. Alignment guides at both ends house grounding contacts and allow blindmateability. SCA-2 receptacles are installed on backplane to mate directly with SCA-2 plugs installed on disk drive. Tail configurations include through-hole pin and press-fit compliant pin. 80-pin receptacle supports SCSI-3 protocol, while 40-pin...

Read More »
Signal Processors

Digital Signal Processor operates at 250 MHz.

ADSP-TS101S TigerSHARC DSP offers 250 MHz clock rate, 1500 MFLOPS performance and native support for 8, 16, 32, and 40-bit data types. It has 1.5 W power dissipation, 6 Mbit of on-chip memory, 14 channel zero-overhead DMA engine, integrated SDRAM controller, parallel host interface, cluster multiprocessing support, and link port multiprocessing support. Applications include data acquisition,...

Read More »
Electronic Boards

Controller Board is designed for PC/104-based systems.

PCMCIA dual interface board is designed to add PC card I/O functionality to PC/104 system such as fax/modem, networking, flash memory, video capture, GPS, SCSI adapter, parallel adapter, serial adapter or ISDN. It has Intel(R) PD6722 chip, and is available with either 2 front-, right- or left-loading PCMCIA disk drives. Board supports all Type I, II, and III PCMCIA memory; I/O; and ATA hard disk...

Read More »
Reverse Expansion Insert presses into plastic hole.
Inserts

Reverse Expansion Insert presses into plastic hole.

Suitable for strengthening plastic joints, Series 18 brass reverse expansion insert is used in applications where bolt enters insert from headless end rather than from headed end. Its head provides high level pull-through resistance and its diamond knurl provides directional torque resistance for bolt installation. Unit does not require any specialized insertion tools, so it can be installed by...

Read More »
Optical Receivers utilize receive and regenerate functions.
Signal Receivers

Optical Receivers utilize receive and regenerate functions.

DSC-R601 provides type K coaxial RF output, and has single-ended limiting amplifier providing constant -300 mVpp to following stages with optical input powers from -20 to +0 dBm. DSC-R602 provides dual sub-miniature coaxial outputs, and has differential limiting amplifier providing constant -600 mVpp to following stages with optical input powers from -20 to +0 dBm. Applications include DWDM...

Read More »
Clock Recovery Modules suit OC-192 and 10GbE markets.
Oscillators

Clock Recovery Modules suit OC-192 and 10GbE markets.

M840 Series multi-rate clock recovery modules use phase-lock loop architecture and low-noise SAW VCO to provide low jitter clock and data outputs for fiber optic networks. Typical data output jitter at 9.953 GB/s is less than 8ps p-p. First module in M840 Series is available with data rates of 9.953, 10.3125, 10.664 and 10.709 Gb/s integrated into single unit. Key features include low noise and...

Read More »
Capacitor Switch provides 100,000 operations.
Switches

Capacitor Switch provides 100,000 operations.

VerSaVac(TM) II LE pole top capacitor switch has long life solenoid operating mechanism that operates as low as 80 Vac. No oil or gas is used for interruption or insulation. Switch can be used to replace existing oil switches or used with new capacitor banks. VerSaVac II LE can also be used in conjunction with Zero Voltage Closing Control, which mitigates transients associated with bringing...

Read More »
MOSFET Op Amp produces high power.
Electronic Amplifiers

MOSFET Op Amp produces high power.

PA17 high voltage power operational amplifier offers current rating of 50A continuous or 100A pulse with power dissipation of 850W and slew rate of 50V/microsecond. It has 4-wire current limit circuit, 200 V supply, external shut down control, and optional boost voltage inputs. Applications include semiconductor testing, sonar transducer driver and linear and rotary motor drives.

Read More »
Electrical Connectors

Power Grip Connectors meet ANSI C119.4 specs.

UTILCO Power Grip Hot Line Connectors for high current overhead and equipment tap applications have direct drive eyebolt that is in line with V shaped jaw, creating mechanical wedge that assures constant 3-point loading on connection. Grooves in jaw serve to remove cable oxidation, thus improving integrity of connection as it is being installed. Power Grips accommodate multiple sizes of...

Read More »
Signal Conditioner takes signals from RCCs.
Electronic Amplifiers

Signal Conditioner takes signals from RCCs.

Single-channel Model 2775B bench-top amplifier accepts inputs from PE, ISOTRON or remote charge converters (RCCs) with input range from 0.01 to 100,000 engineering units. It operates from input power of 90-240 Vac. Setup is accomplished manually on unit's front panel or via RS232 interface and optional software. Unit has switchable isolation, gain range of 0 to 10,000, and frequency response of...

Read More »
Let Our Safety Experts Lower Your Risk
Sponsored

Let Our Safety Experts Lower Your Risk

Elite Technical Services provides your company with qualified and experienced safety experts. Specializing in confined space and high-angle technical rescue and jobsite hazard assessment, your workplace safety is the top priority. Check out the video to learn more.

Read More »

All Topics

COVID-19 Response Suppliers COVID-19 Response:
Can Your Company Help Provide Critical Supplies?

We are using the power of our platform to aid in the mass shortage of critical supplies. If your company can help provide supplies, capabilities, or materials for products such as N-95 Masks and Tyvek SuitsPlease let us know.

COVID-19 Response Suppliers