Electronic Components & Devices

Voltage-Controlled Oscillator uses internal SAW resonator.
Oscillators

Voltage-Controlled Oscillator uses internal SAW resonator.

Surface-mount M650 Series uses high Q resonator, operating at fundamental frequency of end unit, to provide low-jitter frequency translation in telecommunications applications. Oscillator has 3.3 V operation, output frequencies from 155 to 900 MHz, and ground plane for added phase noise performance, with -93dBc/Hz@1KHz offset typical. Applications include clock smoothing, frequency translation,...

Read More »
Radial Resistors are available from 1 Ohm to 100 Meg.
Resistors

Radial Resistors are available from 1 Ohm to 100 Meg.

Type MK132V/MK632V non-inductive film resistors come in CK06 style package with ratings of 400V, 0.75 W at 125 deg C. Tolerance of 1% is standard and TC is 50 ppm/°C from 5 ohms to 5 Meg. Resistors have molded case with V stand-offs and radial leads on 0.20 in. centers. They are suitable for use in industrial controls, avionics, power supplies, amplifier circuits, and general test equipment.

Read More »
Ballast operates 57-watt fluorescent lamp.
Lighting Ballasts

Ballast operates 57-watt fluorescent lamp.

SmartMate(TM) ICF-2S42-M2 ballast is designed to operate 1 triple compact fluorescent lamp, which provides approx 4,300 initial lumens at 25 deg C. Ballast is available with length mounting feet or bottom-mount PEM studs, and single-entry or dual-entry connectors. IntelliVolt(TM) universal voltage allows operation on systems ranging from 120 to 277 V, 50/60 Hz. Ballast offers lamp end-of-life...

Read More »
Interconnect System has phosphor bronze contacts.
Electrical Connectors

Interconnect System has phosphor bronze contacts.

AMPMODU Micro Interconnect System, based on high-density 0.8mm centerline contacts, is suitable for cable-to-board, cable-to-cable, and board-to-board applications. Dual row connector is available in 4 through 40 positions. F crimp for 28 AWG wire provides wire termination, and contacts terminated to 28 AWG wire are rated at 1 amp. Housings are SMT compatible UL 94V-0 LCP, and temperature rating...

Read More »
Receptacles support SCSI and FC-AL systems.
Connectors

Receptacles support SCSI and FC-AL systems.

SCA-2 receptacles consist of staggered contact heights which enable hot-plugging. Alignment guides at both ends house grounding contacts and allow blindmateability. SCA-2 receptacles are installed on backplane to mate directly with SCA-2 plugs installed on disk drive. Tail configurations include through-hole pin and press-fit compliant pin. 80-pin receptacle supports SCSI-3 protocol, while 40-pin...

Read More »
Signal Processors

Digital Signal Processor operates at 250 MHz.

ADSP-TS101S TigerSHARC DSP offers 250 MHz clock rate, 1500 MFLOPS performance and native support for 8, 16, 32, and 40-bit data types. It has 1.5 W power dissipation, 6 Mbit of on-chip memory, 14 channel zero-overhead DMA engine, integrated SDRAM controller, parallel host interface, cluster multiprocessing support, and link port multiprocessing support. Applications include data acquisition,...

Read More »
Electronic Boards

Controller Board is designed for PC/104-based systems.

PCMCIA dual interface board is designed to add PC card I/O functionality to PC/104 system such as fax/modem, networking, flash memory, video capture, GPS, SCSI adapter, parallel adapter, serial adapter or ISDN. It has Intel(R) PD6722 chip, and is available with either 2 front-, right- or left-loading PCMCIA disk drives. Board supports all Type I, II, and III PCMCIA memory; I/O; and ATA hard disk...

Read More »
Reverse Expansion Insert presses into plastic hole.
Inserts

Reverse Expansion Insert presses into plastic hole.

Suitable for strengthening plastic joints, Series 18 brass reverse expansion insert is used in applications where bolt enters insert from headless end rather than from headed end. Its head provides high level pull-through resistance and its diamond knurl provides directional torque resistance for bolt installation. Unit does not require any specialized insertion tools, so it can be installed by...

Read More »
Optical Receivers utilize receive and regenerate functions.
Signal Receivers

Optical Receivers utilize receive and regenerate functions.

DSC-R601 provides type K coaxial RF output, and has single-ended limiting amplifier providing constant -300 mVpp to following stages with optical input powers from -20 to +0 dBm. DSC-R602 provides dual sub-miniature coaxial outputs, and has differential limiting amplifier providing constant -600 mVpp to following stages with optical input powers from -20 to +0 dBm. Applications include DWDM...

Read More »
Clock Recovery Modules suit OC-192 and 10GbE markets.
Oscillators

Clock Recovery Modules suit OC-192 and 10GbE markets.

M840 Series multi-rate clock recovery modules use phase-lock loop architecture and low-noise SAW VCO to provide low jitter clock and data outputs for fiber optic networks. Typical data output jitter at 9.953 GB/s is less than 8ps p-p. First module in M840 Series is available with data rates of 9.953, 10.3125, 10.664 and 10.709 Gb/s integrated into single unit. Key features include low noise and...

Read More »

All Topics

COVID-19 Response Suppliers COVID-19 Response:
Can Your Company Help Provide Critical Supplies?

We are using the power of our platform to aid in the mass shortage of critical supplies. If your company can help provide supplies, capabilities, or materials for products such as N-95 Masks and Tyvek SuitsPlease let us know.

COVID-19 Response Suppliers