Electronic Components & Devices

Filter Elements resist pressure, temperature, and corrosion.
Filters

Filter Elements resist pressure, temperature, and corrosion.

Knitted Wire Mesh Filter Elements (KWFE) offer alternative to sintered metals, plastics, paper, and cloth. Continuous lengths of uniform interlocking wire loops strengthen KWFE to provide vibration resistance. Available in plastic and metal alloy materials, KWFE can be used in applications that require flame resistance. Wire gauge, knit spacing, and degrees of compression provide various...

Read More »
Signal Conditioner controls multiple units.
Electronic Amplifiers

Signal Conditioner controls multiple units.

Rack-mountable Model 2775B fits 1 to 6 units in 19 in. enclosure. It allows centralized control of up to 20 units per COMM port via RS-232 computer interface. Offerings include dynamic range from 0.01 to 100,000 engineering units and sensor input sensitivity range of 0.0001 to 10,000 mV/EU or pC/EU. It provides 3 outputs: AC output voltage proportional to input, DC output voltage proportional to...

Read More »
Bus Clock Synthesizers replace up to 8 discrete ICs.
Frequency Synthesizers

Bus Clock Synthesizers replace up to 8 discrete ICs.

SY89532/3/4/5 PLL-based precision bus clock synthesizers integrate 3 clock dividers, translator, and 3 fanout buffers into single, 64-pin TQFP package. They accept quartz-crystal oscillator input or differential or single-ended reference input, and provide LVPECL or LVDS output frequency between 33 and 500 MHz. Three output banks are independently programmed for target output frequencies. Jitter...

Read More »
Battery Formation Rectifier suits automotive applications.
Rectifiers and Diodes

Battery Formation Rectifier suits automotive applications.

BC/HD (battery charging/high density) system is suitable for formation of automotive, or flooded, lead-acid batteries. It can also be used for VRLA and high-production, water-bath formation installations. System is available with output currents of 10 to 60 A and output voltages up to 450 Vdc. Depending upon output and control requirements, it uses either Micro Me cabinet controller or...

Read More »
MOSFET BGAs work with battery packs.
Arrays

MOSFET BGAs work with battery packs.

FDZ2551N and FDZ2553N dual N-channel and FDZ2552P and FDZ2554P P-channel 20 V MOSFET ball grid arrays have physical and electrical characteristics that are suitable for Li-Ion battery pack protection applications. Each BGA is housed in 4 x 2.5 mm surface mount package, and has common drain connection and 0.8 mm mounted height. RDS(On) is 28 mohm and 14 mohm for N and P channel devices,...

Read More »
Converters

Analog-to-Digital Converter employs SAR architecture.

Model MCP3221, 12-bit converter offers I2C(TM) interface in SOT-23 package. Its design permits operation with typical standby and active currents of 5 nA and 175 micro-amps respectively. Fast mode (400 kHz clock rate) enables sampling rates to 22.3 kilo-samples per second (ksps). Suited for remote applications, unit has single supply operation and operates over range of 2.7 to 5.5 V and offers...

Read More »
Adjustable Arm ergonomically positions monitors.
Mounts

Adjustable Arm ergonomically positions monitors.

Gas Assist Monitor Arm allows operators to adjust position of computer monitors horizontally and vertically over range of 12 in. Support plate for monitor has locking tilt function for precise positioning. Arm can be installed on wall, table, or desk and adjusted exactly to operator's comfort level. It supports up to 65 lb, and has abrasion resistant baked enamel finish.

Read More »
Lamp Ballasts meet new pulse start specs.
Lighting Ballasts

Lamp Ballasts meet new pulse start specs.

Linear Reactor ballasts for pulse-start metal halide lamps have automatic reset thermal protection that interrupts power to ballast in event of abnormal lamp or ballast failure. They meet existing and newly proposed pulse-start ANSI specifications. Ballasts are available for various metal halide lamp wattages, including: 150 W (ANSI Code M102/M142), 200 W (M136), 250 W (M138/M153), 320 W...

Read More »
Single Chip USB UART upgrades RS232 systems.
Electronic Adapters

Single Chip USB UART upgrades RS232 systems.

FT232BM transfers serial data over Universal Serial Bus. It can be used to upgrade older RS232 serial designs to USB with minimal development and cost. It incorporates reset and clock circuits, 5V/3.3V UART output voltage, data transfer rates of up to 920 k baud for RS232, and 3,000 k baud for RS422/RS485. Royalty free drivers are available.

Read More »
Precision Machined Parts for High Tech Applications
Sponsored

Precision Machined Parts for High Tech Applications

For precision and value that sets the standard for quality and craftsmanship, EGS Production Machining is the source for precision and value. Our extensive capabilities and dedication to customer service allow us to deliver the optimal manufacturing solution. See our video to learn more.

Read More »

All Topics