Electronic Components & Devices

Dual Filter provides matched response.
Filters

Dual Filter provides matched response.

Model LT1568 ultra low noise (92 dB SNR) filter provides one pair of matched second order filter sections integrated on one chip. Matched filter response, gain, and phase repeatability from channel to channel is suited for I/Q applications. Internal passive and active circuitry is precisely trimmed for predictable and repeatable performance. Offered with single-ended or differential outputs, unit...

Read More »
Oscillator suits portable, handheld, and wireless markets.
Oscillators

Oscillator suits portable, handheld, and wireless markets.

FOX923E temperature compensated, voltage controlled crystal oscillator measures only 3.2 x 2.5 x 1.2 mm. Frequency range is 13-26 MHz with supply voltage range of 2.85-3.15 VDD, and initial frequency tolerance of -0.5 to +0.5 ppm at 77°F ±35.6°F. Standard operating temperature is -4 to 167°F. Frequency stability is -2.5 to +2.5 ppm over temperature range and -0.2 to +0.2...

Read More »
Herding Filter suits automotive applications.
Filters

Herding Filter suits automotive applications.

Silicone- and textile-free filters allow paint to adhere properly to vehicle surface. They prevent dust and fine particles from being drawn into vacuum pump and escaping into surroundings. Products comply with FDA, GMP, and 3-A requirements and are suitable for powders with particle size of .5 micron and greater, depending on powder properties. Sintered polyethylene body is coated with PTFE.

Read More »
Multi-Bag Filter Vessel reduces bag change time to 15 sec.
Filters

Multi-Bag Filter Vessel reduces bag change time to 15 sec.

Suited for industrial and commercial applications, SE MAXILINE(TM) reduces downtime required for filter media changing. Design incorporates spindle/interlock mechanism with integral QIC-LOCK® clamp, which prevents cover from being opened until vessel has been properly vented. Vessel cannot be re-pressurized until clamp has been fully closed and safety interlock engaged. Low-profile design...

Read More »
Wire Terminals facilitate manufacture of power cords.
Electrical Terminals

Wire Terminals facilitate manufacture of power cords.

Male Twist Lock Terminals, with crimp ear that accommodates 10-16 AWG wire, eliminate need for tooling changes from one wire size to another. Offered in NEMA L5-15P (125 V), NEMA L6-15P (250V), and NEMA L7-15P (277 V) configurations for molded power cords, they are supplied in both strip form and as loose pieces. Products are constructed from 260 cartridge brass and rated 15 A.

Read More »
Magnetic Mat organizes tools and fasteners.
Management Systems

Magnetic Mat organizes tools and fasteners.

Flexible, non-conductive, PVC MagnaMatPro(TM) measures 12 in. sq x 3/16 in. thick. Neodymium iron-boron magnets hold up to 20 lb of metal tools, fasteners, and other ferrous objects. Mat also serves as magnetic sweep to retrieve objects such as nails, nuts, bolts, and washers that fall onto ground or out of reach. MagnaMatPro adheres to any iron or steel surface, flat or curved, coated or...

Read More »
Integrated Circuit powers automotive and industrial motors.
Circuits

Integrated Circuit powers automotive and industrial motors.

Full-bridge, pre-driver Model A3940, suited for large, brush, DC motors, provides 4 gate-drive outputs capable of driving various N-Channel MOSFETs. Bootstrap capacitors provide above-battery supply voltage required for N-Channel FETs, while internal charge pump for high side allows for DC, 100% duty cycle, operation of bridge. PHASE and ENABLE input terminals are provided for controlling speed...

Read More »
Socket/Ratchet Sets deliver SuperTorque® fastening power.
Ratchets

Socket/Ratchet Sets deliver SuperTorque® fastening power.

With low profile design, socket and ratchet sets engage fastener flats for higher torque application. Configurations include: 14-piece, Â-¼ in. drive set; 12-piece, 3/8 in. drive set; 21-piece, 3/8 in. drive set; 12-piece, ½ in. drive set; and 17-piece, ½ in. drive set. Detents on all socket inner walls ensure tight, positive engagement with drive tool in any orientation....

Read More »
LED Modules connect to form customized lighting.
Rectifiers and Diodes

LED Modules connect to form customized lighting.

StripLED® Connectable LED Modules each contain 4 bright, wide-angle (85Â-º) SpiderLEDs, 3 in. double-ended connector harness for daisy chain assembly, and pre-applied strip of 3M® double-sided foam tape. LEDs are wired in parallel and function independently. They are impervious to shock, vibration, frequent switching, and environmental extremes. Average life span is 100,000+...

Read More »
Pull Pins incorporate plastic handles.
Pins

Pull Pins incorporate plastic handles.

Spring-loaded pull pins, with ball or T-handles, allow users to quickly retract and engage plunger for locating, fastening, and quick-change operations. Housing, made of 12L15 steel for welding to fixture, accepts fully retracted plunger. Pins are available with plunger diameters from 1/4-5/8 in. Plungers, made from 1038 steel, have tensile strength of 90-95 ksi on all sizes except 5/8 in., which...

Read More »

All Topics

COVID-19 Response Suppliers COVID-19 Response:
Can Your Company Help Provide Critical Supplies?

We are using the power of our platform to aid in the mass shortage of critical supplies. If your company can help provide supplies, capabilities, or materials for products such as N-95 Masks and Tyvek SuitsPlease let us know.

COVID-19 Response Suppliers